24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

CLICK HERE FOR A FREE QUOTATION

If you are an owner of Ruud furnace or operate it at your work, you may encounter with Ruud furnace error codes appearing in the operation process. The tables on the page describe the codes, flashes, blinks and other problem signals and let you understand what is going on with the equipment at a certain moment.


Ruud R801T Furnace Error Code

CODE: 0.
RESULT: Standby.

CODE: C.
RESULT: Compressor on (cooling or heat-pump heat).

CODE: H.
RESULT: Gas heat on.

CODE: F.
RESULT: Continuous fan on.

CODE: 10.
RESULT: 1 hour lockout.

CODE: 11.
RESULT: Failed ignition.

CODE: 12.
RESULT: Low flame sense.

CODE: 13.
RESULT: Flame lost.

CODE: 14.
RESULT: Unexpected flame.

CODE: 20.
RESULT: Twinning fault.

CODE: 22.
RESULT: Main limit open.

CODE: 26.
RESULT: Line and neutral reversed.

CODE: 33.
RESULT: Mrlc (manual reset limit control) (aka roll-out) open.

CODE: 55.
RESULT: Pressure switch stuck closed when should be open.

CODE: 57.
RESULT: Press switch stuck open when should be closed.

CODE: 61.
RESULT: Blower fault-blower unable to run.

CODE: 93.
RESULT: Internal control fault.

Ruud U98V Furnace Error Code

FLAME LED: OFF.
RESULT: No flame is detected.

FLAME LED: Rapid blink.
RESULT: Unexpected flame.

FLAME LED: Slow blink.
RESULT: Marginal flame sense.

FLAME LED: Steady ON.
RESULT: Normal flame detected.

STATUS LED: Steady ON.
RESULT: Furnace.

STATUS LED: 1 Blink.
RESULT: Ignition failure, 1 HR lockout.
FIX: Reboot system.

STATUS LED: 2 Blinks.
RESULT: Pressure switch stuck open, switch will not close when inducer is on.
FIX: Try to manually close the switch, replace the switch, or check blowers and vents for air pressure.

STATUS LED: 3 Blinks.
RESULT: Limit switch open, main limit or roll out control
FIX: Check for a restricted air vent, loose blower wheel, a defective blower, or a dirty air filter.

STATUS LED: 4 Blinks.
RESULT: Pressure switch stuck closed, switch will not open.
FIX: Check for an obstruction in the pressure tubing.

STATUS LED: 5 Blinks.
RESULT: Not applicable.

STATUS LED: 6 Blinks.
RESULT: Line and neutral reversed.
FIX: Control board or the furnace's ground could be defective.

POWER LED: OFF.
RESULT: No power (24 VAC) to control board.

POWER LED: ON.
RESULT: Control is powered.

Ruud R802P Furnace Error Code

FLAME LED: OFF.
RESULT: No flame is detected.

FLAME LED: Rapid Blink.
RESULT: Unexpected Flame.

FLAME LED: Slow Blink.
RESULT: Marginal Flame Sense.

FLAME LED: Steady ON.
RESULT: Normal Flame Detected.

STATUS LED: Steady ON.
RESULT: Normal Fault detected.

STATUS LED: 1 Blink.
RESULT: Ignition failure, 1 HR lockout.

STATUS LED: 2 Blinks.
RESULT: Pressure switch stuck open switch will not close when inducer is on.

STATUS LED: 3 Blinks.
RESULT: Limit switch open main limit or roll-out control.

STATUS LED: 4 Blinks.
RESULT: Pressure switch stuck closed. Switch will not open.

STATUS LED: 5 Blinks.
RESULT: Not applicable.

STATUS LED: 6 Blinks.
RESULT: Line and Neutral reversed.

POWER LED: OFF.
RESULT: No power (24VAC) to control board.

POWER LED: ON.
RESULT: Control is powered.

Ruud R96P Furnace Error Code

GREEN LED: ON.
RESULT: Normal operation.

GREEN LED: 1 Flash.
RESULT: Ignition failure (4 trials).

GREEN LED: 2 Flashes.
RESULT: Pressure switch stuck open.

GREEN LED: 3 Flashes.
RESULT: Limit switches open.

GREEN LED: 4 Flashes.
RESULT: Pressure switch stuck closed.

GREEN LED: 5 Flashes.
RESULT: Twin fault.

GREEN LED: 6 Flashes.
RESULT: Brownout voltage.

GREEN LED: 7 Flashes.
RESULT: Hot and neutral reversed or no ground.

GREEN LED: Continuous.
RESULT: Gas valve relay short.

YELLOW LED: Rapid Blink.
RESULT: Flame out of sequence.

YELLOW LED: Slow Blink.
RESULT: Low flame or no flame.

YELLOW LED: ON.
RESULT: Flame present.


See What Our Customers Are Saying:

by Todd Whyte on Twintech Heating and Cooling

My existing 15-yr old A/C went down on me during the first major heatwave of the season. Researched my options, as well as a few different installers, and decided on Twintech.

They gave me confidence right from the beginning. Extremely knowledgeable. Their communication was excellent - always responded to questions quickly. Given we were in a heatwave, they were fully booked. However, within days they were able to fit me in due to a cancellation. Upon learning that the Amana unit I was getting installed was on backorder, TwinTech went to bat for me with the manufacturer and was able to get me the next model up within a day, for the same price - Amazing!

As far as the installation was concerned, I couldn’t be more impressed. These guys were clearly very experienced and did a fantastic job. Very clean, polite, timely & informative. They even thoroughly sealed all the exposed gaps in my ductwork. I’ve had plenty of heating and cooling work done in the past and have never used the same contractor twice because I’ve never been very impressed. However, from now on, I’ll always be contacting Twintech first!

by Jordan Arnott, Courtice on Twintech Heating and Cooling

They were very friendly and took care of everything. The install looks great (and works great), they were very knowledgeable. Installed our a/c efficiently despite the difficult install location both inside and outside and they made it work.

by Lori Ellis on Twintech Heating and Cooling

Phenomenal service, so glad I found these guys a few years back after being "hosed" badly by 3 other companies. I've recommended them to so many, and they all are so thankful.

by Jonathan Rogoza on Twintech Heating and Cooling

This company is fantastic. Dave came out and gave me a very honest and reasonable quote, unlike a quote received from another company. I had a bunch of questions that were easily answered and when I had questions regarding heating/cooling a previously unheated room above the Garage, Dave arranged for Greg to come out for an assessment of this new space and gave me his recommendation along with his professional thoughts on all of my options.

These guys have been nothing but Professional, honest and helpful along the way. I can't recall the two other guys doing the install, but they were great as well. Good workmanship, everything was cleaned up and everything functions as promised. I could go on and on about my experience, but it's all positive so what more could you want?

Give them a call, see for yourself. If I had to buy another furnace/AC or heat pump, they'd be my first call.

by Private User on Twintech Heating and Cooling

I hired twin tech to convert my townhouse heating from electric to gas and install a furnace and a/c unit. I had talked with many other vendors, and received several quotes, but chose them, and very happy I did. Here are some of the reasons why:
1. They were realistic about the timeline for the work, when they could start and how long it would take. (They said upfront, it was their busy season and would need to get back to me in 3 weeks, which they did):
2. They had a quote with options for me. They were clear about the entertainment of what they would and would not do (they’d build duct work, id need another contractor to box in ductwork). This allowed me to plan as I was my own general contractor for my renovations).
3. They spoke to me in a language I understood, neither too technical nor too simple. They answered all my questions as I had them. Everyone is so lovely to work with, the sales team and the contractors who are worked in my home.
4. It’s been 4 m since the work was complete. They still answer my emails and my furnace is working very well!

I unabashedly recommend! Price, customer care and quality workmanship were all amazing!

by Anna Chin, Ajax on Twintech Heating and Cooling

On one of the coldest days of winter, our furnace stopped working. Our regular furnace company came and told us we had a CO2 leak and shut us off. Their quote for a new furnace was way too high and they couldn't even install it on the same day. TwinTech was recommended to us by a friend. We called and spoke to Dave who was very nice and knowledgeable. Grant showed up a short time later and a new furnace was installed the same day with no troubles at all. Best of all, we received a higher-end furnace than what was offered by our previous company and at a cheaper price. I would recommend TwinTech with no hesitation at all.

by Hiba, Pickering on Twintech Heating and Cooling

I installed a new furnace and Air conditioner with them. The installation is of high quality and according to standards. The guys are professional and reasonably priced.. I highly recommend them.

by Robert, Pickering on Twintech Heating and Cooling

Had new furnace installed and ran into some difficulties but the contractor responded in a timely and efficient manner - after further service calls were made, a reasonable resolution was found.

by Brian Burns, Whitby on Twintech Heating and Cooling

The work was done quickly efficiently neatly and professionally. Pleased with the service, information, product, and the company.

by Geoff, Port Perry on Twintech Heating and Cooling

Great sales member named Dave came in told us some amazing items and how they would be priced installed an all. We couldn’t believe it! The next day the ac was installed, that day one employee named Greg told us that our furnace was working way to hard and was causing us to use way too much gas. So two days later they came in an installed a new furnace!