24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

CLICK HERE FOR A FREE QUOTATION

The flashing LEDs on your A/C will correspond to a specific fault code that is shown here.

Comfort Alert Diagnosis Chart Single Phase Unit.


CODE: Green "POWER".
RESULT: Module has power.
FIX: Supply voltage is present at module terminals.

CODE: Red "TRIP".
RESULT: Thermostat demand signal Y1 is present, but the compressor is not running.
FIX: Compressor internal overload is open. Broken wire or connector is not making contact. Low pressure switch open, if present. Compressor contactor has failed open.

CODE: Yellow "ALERT" Flash Code 1.
RESULT: Long Run Time Compressor is running extremely long run cycles.
FIX: Low refrigerant charge. Evaporator blower is not running. Evaporator coil is frozen. Faulty TXV. Condenser coil is dirty. Liquid line restriction (filter drier blocked if present in system). Thermostat is malfunctioning.

CODE: Yellow "ALERT" Flash Code 2.
RESULT: System Pressure Trip Discharge or suction pressure out of limits or compressor overloaded.
FIX: Condenser coil poor air circulation (dirty, blocked, damaged). Condenser fan is not running. Return air duct has substantial leakage. If low pressure switch is present, check flash code (1) information.

CODE: Yellow "ALERT" Flash Code 3.
RESULT: Short Cycling Compressor is running only briefly.
FIX: High head pressure. Thermostat demand signal is intermittent. Time delay relay defective, if present. Hot gas sensor defective, if present.

CODE: Yellow "ALERT" Flash Code 4.
RESULT: Locked Rotor.
FIX: Run capacitor has failed. Low line voltage (contact utility if voltage at disconnect is low). Excessive liquid refrigerant in compressor. Compressor bearings are seized.

CODE: Yellow "ALERT" Flash Code 5.
RESULT: Open Circuit.
FIX: Compressor contactor has failed open. High pressure switch is open, If present. Open circuit in compressor supply wiring or connections. Unusually long compressor protector reset time due to extreme ambient temperature. Compressor windings are damaged.

CODE: Yellow "ALERT" Flash Code 6.
RESULT: Open Start Circuit Current only in run circuit.
FIX: Run capacitor has failed. Open circuit in compressor start wiring or connections. Compressor start winding is damaged.

CODE: Yellow "ALERT" Flash Code 7.
RESULT: Open Run Circuit Current only in start circuit.
FIX: Open circuit in compressor run wiring or connections. Compressor run winding is damaged.

CODE: Yellow "ALERT" Flash Code 8.
RESULT: Welded Contactor Compressor always runs.
FIX: Compressor contactor has failed closed. Thermostat demand signal not connected to module.

CODE: Yellow "ALERT" Flash Code 9.
RESULT: Low Voltage Control circuit < 17VAC.
FIX: Control circuit transformer is overloaded. Low line voltage (contact utility if voltage at disconnect is low).


See What Our Customers Are Saying:

by one19 in North york on Twintech Heating and Cooling

Greg came by to do a routine furnace checkup. He was very knowledgeable and professional, letting me know what's being checked/adjusted and giving me tips to ensure everything runs smooth. Very honest and upfront about what's working fine vs. what may need to be fixed/replaced. He didn't attempt to up sell anything that wasn't necessary. I'm glad to have finally found someone I can trust and rely on for all my HVAC needs - furnace, A/C, and hot water tank.

by Paul M. from Toronto on Twintech Heating and Cooling

I'm very happy with the work that was done. Everyone from salesperson to the installers were friendly and professional. They were on time and cleaned up the job site after it was installed. They also answered all my follow up questions promptly. I wouldn't hesitate to work with them or recommend them again.

by Kathy D.in Ajax on Twintech Heating and Cooling

Thanks to the team at Twin Tech for a great job installing my new heat pump/ac unit. The guys were very polite and professional. When they left you would never have known they had been there except for the new Mitsubishi unit on the wall!! would highly recommend the Twin Tech team.

by varga p. in Pickering on Twintech Heating and Cooling

Installed professionally, no delays, no rework needed. Very reliable contractor and sales person. Also installed BBQ gas line and some duct work.

by Private User on Twintech Heating and Cooling

Greg and Grant are friendly, reliable, and knowledgeable HVAC professionals. The twins, Dave and the entire team provided efficient top quality service. Our family plns to use Twintech for all of our future HVAC needs.

by peter in Whitby on Twintech Heating and Cooling

Very impressed with this company. They show up on time , kept my place clean and after they left it looks like they were never there. Very professional team. Those people know what they doing . Their installation was on the highest standard. They are very knowledgeable especially they're worker Peter. I strongly recommend this company to everybody. After the installation I receive the call making sure I'm satisfied with their products and their job. Bravo!!!

by James in Bowmanville on Twintech Heating and Cooling

Greg and his brother were referred to us by a friend. They arrived when they said they would, did an exceptional job and left the place as tidy or tidier then they found it. Their professionalism is only surpassed by their kind and friendly demeanor. Even after several calls to help me with my high tech thermostat I feel that I could always call with any concern (No one responds to my texts as quickly as Greg) and have a friendly helpful response. I found out their grandfather started the company and now as a 3rd generation company, they are doing their grandfather proud. I would highly recommend Twintech over any other hvac company out there.

by RJW in Ajax on Twintech Heating and Cooling

Thanks to the guys at Twintech Heating for a great job installing a new hot water tank. They set a time and day to remove the old tank and install the new one. They were on time and had the work done quickly and cleaned up after they were finished. Excellent work and great value.

by Marilyn in Milton on Twintech Heating and Cooling

In November, we contacted Twintech for a quote on a high efficiency furnace plus installation. Dave, the sales representative for the company was very friendly and informative. Upon arrival at our home, he willingly showed us his company licenses, clearly explained the operation of a high efficiency furnace and answered all our questions to our satisfaction. As well, Dave was the only sales representative that we contacted that was willing to make the arrangements for an energy audit. For us, this was a big plus as we found the government rebate program somewhat confusing to navigate. The furnace was installed on the date that was arranged in an efficient and professional manner by Greg (the owner) and Peter. Both men worked diligently, throughout a long day to complete the job and upon finishing, left the job site immaculate. When a neighbour raised concerns about the furnace venting location, Greg located an alternative location and resolved the situation with diplomacy. We chose the Napoleon furnace for its excellent warrant;y on the heat exchanger and because it was made in Canada! In addition, to the furnace warranty, Twintech offered us a 5 year warranty on labour which speaks to the quality and pride this team has in their workmanship. It has been over a month now (with some of the coldest January days on record) since we have had the furnace installed. The furnace runs quietly and distributes heat more evenly throughout our 90 year old Toronto home. We can't speak highly enough of the Twintech team and are very satisfied with their workmanship and job ethics. We have no hesitation about recommending them.

by Barry in Toronto on Twintech Heating and Cooling

What more could you ask for! Grant and Greg Dainty provided a professional,diligent and thorough approach to the installation of my furnace. I would highly recommend there services.