keeprite furnace error codes

24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

keeprite furnace error codes
CLICK HERE FOR A FREE QUOTATION

keeprite furnace codes

The flashing LEDs on your furnace will correspond to a specific fault code that is shown here on their diagnostic chart.


International Comfort Products Corporation (ICP) is a company that designs, manufactures and markets central air conditioning (HVAC) systems and gas and oil furnaces for use in homes and commercial buildings. It is a unit of Carrier Global Corporation and is headquartered in Lewisburg, Tennessee, United States.


CODE: LED Off
RESULT: 24 VAC or 115 VAC is off, fuse is open.
FIX: Check whether the door switch isn't closed or for a short circuit.

CODE: LED On
RESULT: Soft lockout, furnace control error, 1 hour delay. If code repeats immediately following power reset, then replace control.
FIX: Will auto-reset after 1 hour.

CODE: Heartbeat
RESULT: Normal operation.
FIX: N/A.

CODE: 2 Flashes
RESULT: Pressure switch closed when should be open.
FIX: Check for an obstruction in the pressure tubing.

CODE: 3 Flashes
RESULT: Pressure switch open when should be closed on single stage models. Low pressure switch open when should be closed on 2 stage.
FIX: Check for: excessive wind; proper vent size; defective inducer motor; defective pressure switch; inadequate combustion air supply; disconnected or obstructed pressure tubing; or restricted vent.

CODE: 4 Flashes
RESULT: Limit switch or rollout open.
FIX: Check for: restricted vent; proper vent sizing; loose blower wheel; excessive wind; dirty air filter; or defective blower.

CODE: 5 Flashes
RESULT: Flame sensed out of sequence.
FIX: Check for a leaky gas valve or a gas valve that is stuck open.

CODE: 6 Flashes
RESULT: Failure to ignite or flame sense lost while running.
FIX: Check for: an ungrounded flame sensor; defective hot surface ignitor; low inlet gas pressure; oxide buildup; manual valve shut off; control ground continuity; inadequate flame carryover; or rough ignition.

CODE: 6 + 1 Flashes
RESULT: Soft lockout - Max of 4 trials for ignition reached (3 hour delay).
FIX: Control will auto-reset after 3 hours.

CODE: 7 Flashes
RESULT: Soft lockout - Limit of roll-out switch open longer than 2 minutes (1 hr delay)(rollout switch requires manual reset).
FIX: A lockout will occur if the limit or flame rollout is open for longer than 3 minutes. Control will auto-reset after 3 hours.

CODE: 8 Flashes
RESULT: Permanent lockout - Gas valve relay contact stuck closed or mis-wired gas valve (power reset only).
FIX: Check for a miswired gas valve or a defective control valve.

CODE: 10 Flashes
RESULT: Line voltage polarity reversed. If twinned, refer to kit instructions.
FIX: Review instructions to correct polarity.

keeprite furnace error codes

keeprite furnace codes


See What Our Customers Are Saying:

by Cibele Ceroni on Twintech Heating and Cooling

Great Team! Furnace broke in the weekend, Bob visited same day and Greg installed new one on Monday. Team was professional, respectful and knowledgeable. Installation went very well, Greg found solutions to challenges, like hiding new conduits in the ceiling. Looks nice and new furnace is working great. Five Stars.

by Jackie Graham on Twintech Heating and Cooling

I used Twintech to install a new furnace for my home. Bob was terrific in explaining the sizing options and why the 2 stage furnace was the best option for me. Greg did a great job installing, clean and on time. Finished work looks great but the best part is how it works. The 2 stage heating is so much more comfortable. I run the fan continuously to keep the indoor air clean. Great investment! Would highly recommendTwintech!

by Anthony Silva on Twintech Heating and Cooling

I’m going to start this by saying I’m a very particular customer. My background is in mathematics and mechanical engineering so I have an eye for detail and a respect for technical knowledge.
Greg had already done an AC inspection and replaced a water heater tank and there was no question in my mind who to deal with replacing my rickety old furnace after it got pooched.
Bob dropped in ahead of time and clearly (and knowledgeably) outlined all technical, price and operational options.
Greg showed up on time, on the agreed date and did a fantastic job. (The OLD furnace was a house of horrors and was installed in a keystone cops sort of way- careless.)
The work Greg did was HIGHLY PROFESSIONAL and FAR MORE FUNCTIONAL than what I had.
I’m also a musician with many instruments so maintaining predictable humidity/temperature is extremely important to me. Greg recognized this as did Bob. You NEVER feel like you’re being brushed off.
In summary, if you’re looking for PROFESSIONAL, QUALITY results by an EXPERIENCED, THOUGHTFUL team
(that also happen to be FRIENDLY and ATTENTIVE ) then you’ve come to the right page!!

by Karen Morgan on Twintech Heating and Cooling

Once again Twin Tech came through and fixed my furnace. A young man by the name of Mitch came by tonight and he was so nice explained everything he was quick he was clean he turned off the lights even when he left the furnace room it’s just above and beyond Twin Tech always delivers and I just found out about them last year and I will use no one else but thanks again Mitch you are fantastic

by Richard Liu on Twintech Heating and Cooling

I had a problem with the Furnace (Armstrong ultra V) and Greg diagnosed it on the phone. Even told me what the issue was and I was able to fix it. This level of service from a Business that is almost unknown today.

If you require service, reach out to Greg. I will definitely use them in the future!

by Tony Forde on Twintech Heating and Cooling

We have been shopping for a heat pump for our home. We had 3 reps come in and make recommendations and provide a quote. Of the 3, Bob was so clearly so much more qualified, thorough and informed than the other two that the decision was a no brainer. As soon as we get our audit results Twintech will be installing our heat pump.

by Private User, Pickering on Twintech Heating and Cooling

knowledgeable sales person, did not try to up-sell unneeded features,
and was easily contacted to ensure customer satisfaction.
Installation was expertly done by friendly guys, everything explained for use of the products. Old products were removed and returned to rental company as part of the service. Follow up call was received to check all was well. This is my second time using this company as I was fully satisfied with my previous air conditioning unit installation

by Private User, Courtice on Twintech Heating and Cooling

Twintech recently installed a new furnace for me. Bob did a great job assessing what I had and needed. All details well explained including the importance of proper sizing of furnace and the value of multi stage heating and the variable speed blower. As a nurse, indoor air quality is a high priority so the variable speed motor running continuous is so good. 24/7 air cleaning. Greg did a great job on install, attention to detail so appreciated. Already notice such an improved comfort and heat. Thank you Twintech! You come as advertised. I will recommend to anyone in need of heating or cooling!

by Walter, Whitby on Twintech Heating and Cooling

We received various quotes from 4 different companies and right away, the prompt and thorough communication from Bob from TwinTech stood out. He introduced himself, sent sample sites and information, and always confirmed any agreed to dates and times.

Bob was friendly and extremely knowledgeable about the topic of HVAC and it was clear he was passionate about his profession. He approached the job as if he was installing in his own home.

Prior to the new furnace & A/C installation, our old units were loud and inefficient - having several rooms feeling too cold in the winter and too hot in the summer. After installing the recommended units, all rooms stay at a consistent temperature- even the finished basement.

I highly recommend the TwinTech team - just an outstanding job at a reasonable price point.

by Private User on Twintech Heating and Cooling

The experience with Twintech was great from the start. Bob the sales manager was friendly and professional and did not use any pressure tactics. He was very knowledgeable.
The installation was completed by the twin owners in about 6-7 hours. Clean quiet easy going didn't mind when I poked my head in to see progress. Highly recommend

Related Links:
oshawa gas furnace problems, ac service call, pickering hvac prices, local ac services, ajax furnace inspection, ac repair services, whitby furnace replacement, furnace repairs pickering, oshawa hvac furnaces, central ac service, ac unit maintenance, pickering gas furnace problems, ac installation near me, ajax hvac repair, hvac repairs, ac contractors, ac repair and service, whitby furnaces, residential furnace, residential ac repair, pickering hvac furnace, pickering furnace service, pickering furnaces, oshawa furnace inspection, oshawa furnaces, nearby ac repair,


keeprite furnace error codes