Furnace Trade-In
Furnace Trade-In

heil furnace error codes

24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

heil furnace error codes
CLICK HERE FOR A FREE QUOTATION

heil furnace codes

If you're looking for help fixing your Heil furnace, look no further! Our comprehensive Heil furnace repair guide will explain common issues, provide troubleshooting tips, and show you how to read your model's error codes..


CODE: Heartbeat.
RESULT: Control has 24 VAC power.

CODE: 2 Flashes.
RESULT: Pressure switch did not open, check for obstructed pressure tubing.

CODE: 3 Flashes.
RESULT: Pressure switch did not close, or re-opened- Check for: excessive wind, proper vent size, defective inducer motor, low inducer voltage, defective pressure switch, inadequate combustion air supply, disconnected or obstructed pressure tubing, low inlet gas pressure, restricted vent, condensate clogged.

CODE: 4 Flashes.
RESULT: Limit circuit fault-a limit or flame rollout is open. Check for: restricted vent, proper vent sizing, loose blower wheel, excessive wind, dirty filter, defective blower motor, defective switch or connections, inadequate combustion air supply.

CODE: 5 Flashes.
RESULT: Abnormal flame proving signal-Flame is proved while gas valve is de-energized. Check for: leaky gas valve, stuck open gas valve.

CODE: 6 Flashes.
RESULT: Failure to ignite or flame sense lost while running. Check for: Flame sensor must not be grounded, low inlet gas pressure, oxide buildup on flame sensor, Manual valve shut off, proper flame sense microamps, gas valve defective or gas valve turned off, defective hot surface igniter, control ground continuity, Inadequate flame carryover or rough ignition, green/yellow wire MUST be connected to furnace sheet metal.

CODE: 7 Flashes.
RESULT: Limit circuit lockout- Lockout occurs if the limit or flame rollout is open longer than 3 minutes. Control will auto reset after 3 hours. Refer to #4.

CODE: 8 Flashes.
RESULT: Gas heating lockout-Control will NOT auto reset. Check for: mis-wired gas valve, defective control valve.

CODE: 10 Flashes.
RESULT: Polarity-Line voltage, polarity reversed. If twinned, refer to twinning kit instructions.

CODE: 1 + 2 Flashes.
RESULT: Blower on after power up- Blower runs for 90 seconds, if unit is powered up during a call for heat (R-W closed) or (R-W) opens during blower on delay.

CODE: 6 + 1 Flashes.
RESULT: Ignition lockout- Control will auto-reset after 3 hours. Refer to #6.

CODE: LED Off.
RESULT: Secondary voltage fuse is open- Check for: door switch not closed, 115VAC at L1 and neutral, 24VAC RED and COM BLUE, 24V Fuse 3A, short circuit in secondary voltage (24VAC wiring).

CODE: LED On.
RESULT: Control circuitry lockout- Auto-reset after one hour.

CODE: LED SOLID.
RESULT: Gas valve relay stuck open- Flame sense circuit failure, software check error, reset power to clear lockout, replace control if status code repeats.

heil furnace error codes

heil furnace codes


See What Our Customers Are Saying:

by Trevor Owens on Twintech Heating and Cooling

I returned from vacation to find my AC unit on the Fritz. After calling way too many places I connected with TwinTech. I’ve used the company in the past for my furnace so I was happy when I recognized Greg at my front door. He’s great and the service is always top notch. I’d highly recommend using twintech for honest, superior service in the Durham region. Thanks!

by Nicole Alain on Twintech Heating and Cooling

I called Twin Tech when my air conditioning stopped working. Greg came over to diagnose the issue - the same day. He was able to diagnose the issue and resolve it quite quickly. Although it was a quick fix, Greg was very thorough in explaining the issue and provided great advice. Not to mention, I felt very comfortable having Greg in my home - which I consider very important when hiring a service provider. Twin Tech will be my go-to from now on. Thank you!!

by Courtney Parkes on Twintech Heating and Cooling

Just hired TwinTech Heating & Cooling to do an A/C Unit removal & reinstall to allow for landscaping access on the side of my house, and they were wonderful!
Bob, Greg & Mitch make a great team! Quick appointment times, super knowledgeable, expert troubleshooting capabilities & very customer service oriented.
I would highly recommend them for all of your HVAC needs! Great job guys!!

by Jacqueline Graham on Twintech Heating and Cooling

Twintech Heating & Cooling installed my furnace in 2022 and in fall of 2023 installed my Panasonic Heat Pump. Greg and Mitch did a great job. Helped me through the rebate process. Super happy with the Heat Pump. Only used my furnace 5 times this winter. Energy bills lower, carbon emissions lower.Thank you Twintech. I recommend highly!

by Bill Grainger on Twintech Heating and Cooling

Just had a new furnace installed by Twintech. I can’t express how great these guys are at what they do. From the sales to installation they were professional all the way. Very reasonable pricing and courteous during the installation and willing to answer any questions I had. Highly recommended !!!

by Colin Vernon on Twintech Heating and Cooling

They've cleaned my furnace a couple of times and mentioned that the hot water tank standards were going to change soon so I decided to change mine out.

There were a few challenges during the process but the installers handled the problems without missing a stride! I now have really hot water again!

by Heidi B on Twintech Heating and Cooling

Highly recommend Twintech Heating company, we got honest and detailed information on what was needed to replace and install a new gas furnace. Bob and Greg made us feel comfortable withe process through their thorough explanation and knowledge of the right furnace for our needs. The professionalism and courteous friendly attitude towards the customer is what we liked the most as they treated us like family. So happy with our decision and new furnace we will be looking into get our rental water heater replaced and installed by Twintech team. We feel better having their knowledge on our side and will only trust them with any further maintenance of furnace.

by Kirushanth Rasiah on Twintech Heating and Cooling

Customer service and knowledge is priority in this industry, and Twintech has it. I've dealt with their team for maintenance and a furnace replacement. They're accommodating and make great recommendations, and came through at a great price over the big guys in the industry. They'll be my next call when I need service or maintenance.

by Leonard Glass on Twintech Heating and Cooling

I decided that the noises and age of the existing furnace which was old and not very efficient to replace it. Gave Greg a call and Grant and Greg got to work on it. Because of supply issues with the current heating type that would be an easier install Greg convinced me to change the location of the system and it would provide me better service for heat and efficiency. I had skeptical but went ahead anyway putting trust in Greg And Grant. Greg, Grant and Mitch came through and in 2 days had completely relocated my heating and A/C system. I can honestly say Greg was right my old house has been warmer and more evenly heated as it ever was. For anyone reading this rather long winded review can take my word for it, Twin Tech can take care of your needs.

by Nicole Alain on Twintech Heating and Cooling

I called Twin Tech when my air conditioning stopped working. Greg came over to diagnose the issue - the same day. He was able to diagnose the issue and resolve it quite quickly. Although it was a quick fix, Greg was very thorough in explaining the issue and provided great advice. Not to mention, I felt very comfortable having Greg in my home - which I consider very important when hiring a service provider. Twin Tech will be my go-to from now on. Thank you!!

Related Links:
oshawa gas furnace problems, ac service call, pickering hvac prices, local ac services, ajax furnace inspection, ac repair services, whitby furnace replacement, furnace repairs pickering, oshawa hvac furnaces, central ac service, ac unit maintenance, pickering gas furnace problems, ac installation near me, ajax hvac repair, hvac repairs, ac contractors, ac repair and service, whitby furnaces, residential furnace, residential ac repair, pickering hvac furnace, pickering furnace service, pickering furnaces, oshawa furnace inspection, oshawa furnaces, nearby ac repair,


heil furnace error codes

See What Our Customers Are Saying:

by Trevor Owens on Twintech Heating and Cooling

I returned from vacation to find my AC unit on the Fritz. After calling way too many places I connected with TwinTech. I’ve used the company in the past for my furnace so I was happy when I recognized Greg at my front door. He’s great and the service is always top notch. I’d highly recommend using twintech for honest, superior service in the Durham region. Thanks!

by Nicole Alain on Twintech Heating and Cooling

I called Twin Tech when my air conditioning stopped working. Greg came over to diagnose the issue - the same day. He was able to diagnose the issue and resolve it quite quickly. Although it was a quick fix, Greg was very thorough in explaining the issue and provided great advice. Not to mention, I felt very comfortable having Greg in my home - which I consider very important when hiring a service provider. Twin Tech will be my go-to from now on. Thank you!!

by Courtney Parkes on Twintech Heating and Cooling

Just hired TwinTech Heating & Cooling to do an A/C Unit removal & reinstall to allow for landscaping access on the side of my house, and they were wonderful!
Bob, Greg & Mitch make a great team! Quick appointment times, super knowledgeable, expert troubleshooting capabilities & very customer service oriented.
I would highly recommend them for all of your HVAC needs! Great job guys!!

by Jacqueline Graham on Twintech Heating and Cooling

Twintech Heating & Cooling installed my furnace in 2022 and in fall of 2023 installed my Panasonic Heat Pump. Greg and Mitch did a great job. Helped me through the rebate process. Super happy with the Heat Pump. Only used my furnace 5 times this winter. Energy bills lower, carbon emissions lower.Thank you Twintech. I recommend highly!

by Bill Grainger on Twintech Heating and Cooling

Just had a new furnace installed by Twintech. I can’t express how great these guys are at what they do. From the sales to installation they were professional all the way. Very reasonable pricing and courteous during the installation and willing to answer any questions I had. Highly recommended !!!

Why Does My Furnace Smell?

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - October 31, 2024

If your furnace has an unusual smell, it could be caused by a variety of issues. Here’s a breakdown of common furnace smells and what they might mean: 1. Burning Dust Smell Cause: If the furnace hasn’t been used for a while (like

Read More

Why is My Furnace Not Heating Properly?

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - October 29, 2023

However, here are some common reasons why a furnace may not be heating properly: Thermostat Settings: Check if the thermostat is set to the desired temperature. Ensure that the thermostat is set to the "Heat" mode.

Read More

AC compressor running but fan not spinning

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - April 18, 2023

Hello everyone, It's about AC season where I live and I did a trial run of the AC to check everything is working ok and the compressor is running but not the fan in the AC unit outside. 2 or 3 years ago this happened and giving the fan a pu

Read More

Is My Furnace Unit Broken?

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - September 24, 2024

If you're wondering whether your furnace unit is broken, here are some signs that may indicate an issue: No Heat or Weak Airflow: If your furnace isn't producing heat or the airflow is weak, there could be a problem with the blower m

Read More