24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

CLICK HERE FOR A FREE QUOTATION

If you're looking for help fixing your tempstar furnace, look no further! Our comprehensive tempstar repair guide will explain common issues, provide troubleshooting tips, and show you how to read your model's error codes.


CODE: Heartbeat LED pattern on solid.
RESULT: The control is locked out and will auto-reset after 1 hour.
FIX: Reset power to clear the lockout.

CODE: Two LED flashes.
RESULT: Pressure switch didn't open.
FIX: Obstructed pressure tubing; a pressure switch that's stuck closed.

CODE: Three LED flashes.
RESULT: The low-pressure switch did not close or has reopened.
FIX: Proper vent sizing; air leak; restricted vent; clogged condensate drain; low input gas pressure; excessive wind; improper pressure switch wiring; water in vent piping; disconnected or obstructed pressure tubing.

CODE: Four LED flashes.
RESULT: Limit circuit fault.
FIX: Loose blower wheel; defective switch or connections; improper minimum- or maximum-heat gas input adjustment; dirty filter or restricted duct system; improper limit switch.

CODE: Five LED flashes.
RESULT: Abnormal flame-proving signal.
FIX: Leaky gas valve; stuck-open gas valve.

CODE: Six LED flashes.
RESULT: Ignition proving a failure.
FIX: Low inlet gas pressure; control ground continuity; gas valve defect; defective hot surface igniter; oxide buildup on the flame sensor; inadequate flame carryover; flame sensor mustn't be grounded.

CODE: Seven LED flashes.
RESULT: Limit circuit lockout.
FIX: Control will auto-reset after 3 hours. Refer to status code #4.

CODE: Eight LED flashes.
RESULT: Gas heating lockout.
FIX: Gas valve stuck closed on control.

CODE: Nine LED flashes.
RESULT: Medium pressure switch, high-pressure switch, or PSR relay didn't close or was reopened.
FIX: Refer to status code #3.

CODE: Ten LED flashes.
RESULT: Polarity.
FIX: Correct line voltage polarity.

CODE: Status codes 1 + 2.
RESULT: Blower on after power up.
FIX: Normal operation.

CODE: Status codes 1 + 5.
RESULT: Blower motor lockout.
FIX: Control will auto-reset after 3 hours. Refer to status code #4 + 1.

CODE: Status codes 3 + 5.
RESULT: Gas valve fault.
FIX: RED, YELLOW, or ORANGE wire at the gas valve.

CODE: Status codes 4 + 1.
RESULT: Blower motor fault.
FIX: Blower failed to reach 250 RPM, or the blower failed to communicate within the prescribed time limits.

CODE: Status codes 4 + 2.
RESULT: Inducer motor fault.
FIX: Proper vent sizing; restricted vent; failed inducer motor; improper motor wiring; a blockage in the tubing to the pressure switch assembly.

CODE: Status codes 4 + 3.
RESULT: The low or medium pressure switch is open while the medium or high-pressure switch is closed.
FIX: Low inlet gas pressure; clogged condensate drain; improper pressure switch wiring; water in vent piping; low or medium pressure switch stuck open; disconnected or obstructed pressure tubing.

CODE: Status codes 6 + 1.
RESULT: Ignition lockout.
FIX: Control will auto-reset after 3 hours. Refer to status code #6.


See What Our Customers Are Saying:

by Nancy H. from Oshawa on Twintech Heating and Cooling

Work was performed in a clean and timely manner. The furnace and metal work was performed by the Twintech team (did not require separate contractor to do the metal work). Energy audit was arranged and promised rebates were received. The overall price was very competitive. We have recommended Twintech to several of our friends and family. Awesome job.

by Syd from Whitby on Twintech Heating and Cooling

Grant and Greg installed a heating and AC system in our new Linwood post and beam home. Post and beam can be challenging structures for running ductwork and their high ceilings and open concept frequently frustrate efforts at balancing air flow and controlling temperatures. But these guys did it and did it right the first time. Even the building inspector was impressed with what he saw. More importantly, the boys brought a high degree of trust and integrity to the job. Something in short supply these days.

by jenner iksmom from Oshawa on Twintech Heating and Cooling

Very polite and professional. They removed my o
ld furnace and A/C and installed my new ones. They were efficient and thoroughly cleaned up when they were done! I would highly recommend them!

by Rob from Toronto on Twintech Heating and Cooling

Pro from start to finish. They were able to fix my gas fireplace at very little cost as well.

by murray mcmichael from Ajax on Twintech Heating and Cooling

Excellent installation very knowledgeable gentlemen! Would highly recommend them to all my friends for any hvac work !

by Private User from Private User on Twintech Heating and Cooling

I have used Twintech many times over the years. They always arrive quickly and get the issue fixed. The most recent incident was when my air conditioner broke last week I called Greg at 11:30am and he was at my home by 2:30pm he had the unit fixed by 3:30pm. Twintech are very reliable and honest and they are experts in the field. I have already recommended them to many of my friends. I would not use anyone but them for my heating and air conditioning issues.

by Kate A in Pickering on Twintech Heating and Cooling

I would highly recommend these guys, professional, fast and competitive pricing. I moved into this place with no working AC unit with a 8 month baby, he was able to come with in a week to fix even in the busy summer days. He really values his customers , I am already recommending to my neighbors.

by Private User in Whitby on Twintech Heating and Cooling

Very impressed they arrive to quote even though I had forgotten to call them back to confirm date & time. They showed the day before installation to deliver the unit. Returned the next day as promised at 9am. Project was completed in a professional manner. They even fixed a few things that they noticed were not installed correctly, or to code by previous heating & air contractors we had at our residence before. Would recommend this company to everyone!

by Private User from Bowmanville on Twintech Heating and Cooling

Greg removed old oil furnace and oil tank from basement relocated new Napoleon propane furnace to allow duct work to be rerouted to a much more suitable location. Moved air conditioner to the new furnace. Dave recommended two available grants to assist with cost. They kept to their original quoted price which was substantially lower than a competitors for the same furnace and work. They completed the work as stated when stated and left the area clean and tidy. We are very pleased with the outcome.

by astephenson in Oshawa on Twintech Heating and Cooling

Twintech installed a Goodman furnace and ac init. Very professional install, both units are working well.