Categories
- AC Filters
- AC Repair
- Air Conditioner Maintenance
- Air Conditioner Repair
- Air Conditioners
- Air Conditioning Services
- Air Quality
- Cleaning Tips
- Cooling
- Duct System
- Ducted Air Conditioner
- Ductless Air Conditioner
- Emergency Repairs
- Energy Costs
- Expert Help
- Fans
- FAQ
- Filters
- Fireplaces
- Fun
- Furnace Installations
- Furnace Repairs
- Furnaces
- Gas Fireplaces
- Gas Line
- Gas Line Installations
- Heat Pumps
- Heating
- Heating and Cooling
- Heating Contractors
- heating system
- Heating Technicians
- Humidity
- HVAC
- HVAC Contractors
- HVAC experts
- HVAC Noises
- HVAC professionals
- HVAC Repairs
- HVAC Service
- Insulation
- Maintenance
- Natural Gas
- Pestibulum molestieenean
- Saving Money
- Water
- Water Heaters
- Work
[BACK]
Humidity issues with ducted Mitsubishi heat pump
Posted On: September 5, 2023
Hello, wondering if others have experienced difficulty maintaining comfortable humidity using a Mitsubishi hyper heat ducted system.
I think the heart of the matter is that they try to be too efficient and can maintain temp well but ignore the importance of humidity.
I have an old inefficient carrier ac downstairs which works great at keep the lower level cool and dry.
My upstairs unit is the heat pump.
I tend to use dry mode as it seems to work better than cool mode since it will try to run longer by keeping the fan speed low and the coil cold.
However, it only really significantly brings down humidity when it's first turned on.
And it does this really well initially.
It can drop eh by like 10% in an hour.
You can repeat this effect by continuing to lower the set point but then you just end up chasing uncomfortably cold temperatures to meet humidity.
If I set it at 74 it will cool until it hits 71 degrees, then shut off and kick back on when it reaches 73.
I could run a portable dehumidifier but they are loud, need to be emptied often unless you have a drain nearby, and consume lots of power.
If I could just hack this thing to run less efficient, ramp up the compressor hit a set point shut off and do it again I think It would be more comfortable.
Or come up with a way to schedule it so that the set point is at 74 then shuts off at 73, unit waits to turn back on at 75 and repeat.
Any thoughts or suggestions?
Thanks.
Question from user Ok-Swan2736 at heatpumps at reddit.
Answer:
Dry mode is 100% cooling.
It could also be that your unit is oversized.
You satisfy temp setpoint before pulling any moisture out of the air.
This is not the fault of your unit, but of your installers system selection.
Answer from user rayinreverse at heatpumps at reddit.
[BACK]
See What Our Customers Are Saying:
Jun 5, 2018
All interactions from sales to installation were Courteous and professional. The installation was seamless and the attention to detail including clean up was outstanding. I highly recommend TwinTech Heating and Cooling.
May 17, 2018
Twintech's Salesman Dave arrived promptly was friendly and courteous, listened and assured us the installation would be completed according to our requests. The crew arrived early morning on May 11th, 2018 and worked through till late afternoon non-stop. They were very friendly, very professional, their expertise was excellent, their workmanship outstanding and the installation was completed in a timely and efficient manner. We were completely satisfied and happy with the quality of the work.
May 9, 2018
I had cold and hot spots all over my 70 yr old home. My furnace is quite new and Greg optimized the fan and furnace. The original installer just took it out of the box with factory settings and installed it- basically running at 50% of capacity. Greg also routed heat into my laundry room, yeah - so now I can renovate laundry room - thanks Greg. He is honest, professional and knowledgeable. I will be calling him back in the spring to optimize my AC as well.
May 8, 2018
Wonderful from beginning to end. I tend to fret and worry about home improvements but the excellent team at TwinTech put my mind as ease. They listen, they are patient and best of all ... the work they did is amazing! I chose the Goodman 80K BTU 2 stage furnace and the matching Goodman air conditioner. Greg, Grant and Poitr "Peter" arrived on time, took great care, explained everything to me and they answered all of my questions. They carefully adjusted the factory settings to optimize the furnace for my house and they also checked the duct work in the basement. Dave, the Sales Manager, came by to say "hello" and to see if I was happy. YES, I am happy with the work! The furnace is very quiet. I have it running on low just to circulate the air in the house and it's so much quieter than my old furnace. When I need new duct work for an upcoming basement renovation TwinTech will be my first choice. I highly recommend TwinTech. PS. They were even nice to my dogs.
Apr 21, 2018
Greg was prompt on the scheduled day of installation and the work was done well within the time estimated beforehand. Installation was neat and the equipment and scope of work was as specified in the quote. One item I must point out is that we were faced with a "No Heat" situation the day before the scheduled installation and Greg came out to address it free of charge. Not only that, but he also corrected an installation fault with our smart thermostat that was not part of the original job, again free of charge.
Mar 16, 2018
Greg came by to do a routine furnace checkup. He was very knowledgeable and professional, letting me know what's being checked/adjusted and giving me tips to ensure everything runs smooth. Very honest and upfront about what's working fine vs. what may need to be fixed/replaced. He didn't attempt to up sell anything that wasn't necessary. I'm glad to have finally found someone I can trust and rely on for all my HVAC needs - furnace, A/C, and hot water tank.
Mar 4, 2018
I'm very happy with the work that was done. Everyone from salesperson to the installers were friendly and professional. They were on time and cleaned up the job site after it was installed. They also answered all my follow up questions promptly. I wouldn't hesitate to work with them or recommend them again.
Feb 28, 2018
Thanks to the team at Twin Tech for a great job installing my new heat pump/ac unit. The guys were very polite and professional. When they left you would never have known they had been there except for the new Mitsubishi unit on the wall!! would highly recommend the Twin Tech team.
Feb 28, 2018
Installed professionally, no delays, no rework needed. Very reliable contractor and sales person. Also installed BBQ gas line and some duct work.
Feb 19, 2018
Greg and Grant are friendly, reliable, and knowledgeable HVAC professionals. The twins, Dave and the entire team provided efficient top quality service. Our family plns to use Twintech for all of our future HVAC needs.
Related Links:
ductwork installation, ductless ac system, ductless ac unit,