Categories
- AC Filters
- AC Repair
- Air Conditioner Maintenance
- Air Conditioner Repair
- Air Conditioners
- Air Conditioning Services
- Air Quality
- Cleaning Tips
- Cooling
- Duct System
- Ducted Air Conditioner
- Ductless Air Conditioner
- Emergency Repairs
- Energy Costs
- Expert Help
- Fans
- FAQ
- Filters
- Fireplaces
- Fun
- Furnace Installations
- Furnace Repairs
- Furnaces
- Gas Fireplaces
- Gas Line
- Gas Line Installations
- Heat Pumps
- Heating
- Heating and Cooling
- Heating Contractors
- heating system
- Heating Technicians
- Humidity
- HVAC
- HVAC Contractors
- HVAC experts
- HVAC Noises
- HVAC professionals
- HVAC Repairs
- HVAC Service
- Insulation
- Maintenance
- Natural Gas
- Pestibulum molestieenean
- Saving Money
- Water
- Water Heaters
- Work
[BACK]
What is the Difference Between Single-Stage, Two-Stage, and Modulating Furnaces?
Posted On: January 8, 2020
When you are looking around for a new furnace, you will come across three different types: single-stage, two-stage and modulating. You may probably ask, what are the differences between them, and which one is right for your home?
In this article, we will explain the differences between them and help you decide which furnace works best for you and your family.
Single-Stage Furnaces
Single-stage furnaces only have one setting, which is high heat. On a call for heat, they immediately start running at full capacity, no matter what the temperature is outside until the signal coming from the thermostat is turned off. These types of furnaces are best suited for budget-conscious consumers, so in the long run, the upfront cost savings are not realized.
Two-Stage Furnaces
A two-stage gas furnace has two settings, high fire and low fire, and here is how it works. Most of the time, on a typical heating cycle the furnace will start out running on low fire, consuming less gas and electricity, while at the same time providing heat and gaining inefficiency. After approximately 7- 10 minutes of operation, the furnace begins to operate very efficiently because it is fully warmed up. Then, it will jump up into high fire and finish out the heating cycle at full capacity. Control of the high and low burner timing are made by the installers, as part of a new furnace installation.
You could also control the 2 stage burner by using a 2 stage thermostat, the effect of either is similar. Two-stage furnaces are considered more energy-efficient than single-stage because they are not always running at a full heating capacity of the appliance and are often equipped with an ECM blower motor which will also save on your electricity costs.
Modulating Furnaces
Modulating gas furnaces are at the top end of the gas furnace spectrum and are considered to be the most energy-efficient of the three. But, at an added price over two-stage or single-stage furnaces. Heating from a modulating furnace ramps up in increments to maintain a consistent temperature and the ductwork is always warmed up so there is a little efficiency lost during the warming up process.
When buying a modulating furnace you will almost always need to invest in a new thermostat controller specifically designed for this type of furnace in order to get the most out of it. Always ask your salesman about this option, as it is often not mentioned (due to the added cost of the new thermostat). If you are planning to stay in your home for the long-term, a modulating gas furnace may be the right fit for you.
When you want to buy a new furnace, you should always consult your local HVAC experts before making a decision. A trained HVAC technician can come to your home, go over your situation with you and help you decide which furnace best suits your home.
When you are ready for a new furnace, contact the Twintech experts! Our technicians are experienced and knowledgeable in all types of furnaces and HVAC systems.
For more information about our services, visit our website or give us a call at 1-844-894-6832. Contact Twintech today!
[BACK]
See What Our Customers Are Saying:
May 16, 2021
Appreciated a quick response to my request. Dave and Greg were very professional and made the experience seamless.
Feb 1, 2021
Very professional through the entire process. Installation and removel was done on a sloppy winter day, they put down runners on the floors and stairs and when they left, there wasn;t any sign of someone being in our house. Furnace works great as promised.
Feb 1, 2021
Dave was very pleasant to deal with and Twintech responded quickly when our furnace needed to be replaced ASAP. Installation was done on time and the crew were neat and tidy. We now have a great furnace that suits the needs of our family.
Feb 1, 2021
When your furnace kicks in over the holidays and you're not sure where to turn.. I'm so thankful that this company returned my phone call. I appreciated their transparency and clarity which allowed me to make an informed decision. With various quotes thrown at you, it can be difficult to make the right decision and trust the solutions offered by different companies. TwinTech spoke the truth and delivered on their word. Neat, timely and clean service; the peace of mind I needed during a very cold holiday season. I highly recommend them!
Feb 1, 2021
Pulling a old unit out and installing a modern heating system! Required drilling holes in the wall for the newer pipes. We went from 70% (I am willing to bet it was far less due to lack of maintenance and just old) to 96% newer . It now feels warmer and more pressure and we use to run extra heaters and feel as though they are not necessary!
Feb 1, 2021
I received three quotes before deciding to choose Twintech. Dave's prices was much more reasonable than the competitors. I most appreciated their honest recommendations. Others tried to oversell their products and services. Thank you Dave!
Feb 1, 2021
They had the best price and did a great job on the installation. Recommend them to anyone.
Feb 1, 2021
It was a amazing and professional high quality job
Friendly and very helpful representatives
Thank you for understanding my concern
And explain very well
Overall we pleased with your service
Tanks
May 15, 2020
My 19 year old furnace stopped working when the cold weather hit in November, and I was left without heat. I interviewed several companies and found TWINTECH HEATING and COOLING to be very knowledgeable, quick to respond to my inquiries and very competitively priced.
Dave provided all of the information and pricing ahead of time and set up the appointment for the installation. Greg and Mitch arrived on time to do the installation and worked quickly and efficiently to complete the job.
After the completion of the installation, Dave followed up to ensure that everything was working well and that I didn't have any concerns.
Overall, this was a low-stress and flawless experience from start to finish. I would highly recommend TWINTECH HEATING and COOLING to anyone that requires a new furnace.
May 14, 2020
Our 20 year old furnace broke down during the first cold weekend this past November and our usual HVAC company never returned our phone call. Their loss, missing out on a sale since we didn't want to spend much fixing an old furnace and our 40 year old air conditioner was also long overdue for replacement. We proceeded in obtaining three different quotes for furnace and air conditioner replacement, and proceeded with the one we received from Twintech.
Dave was friendly, knowledgable and accommodating to our schedule and provided with us with a price that fell in the middle of the three quotes that we had. We felt that the Amana furnace and air conditioner he quoted us on were the best products and value offered to us and felt most comfortable with the professionalism and reputation of Twintech.
Greg, Grant and Mitch were at our house for installation the day after we decided to proceed. The guys were friendly and informative, the job was completed efficiently and workmanship appears excellent. Our house is certainly much more comfortable with the new two-stage variable speed Amana furnace compared to the old clunker! And, we're looking forward to enjoying the new air conditioner once summer rolls around again. Thanks Twintech!
Related Links:
oshawa gas furnace problems, ajax furnace inspection, whitby furnace replacement, furnace repairs pickering, oshawa hvac furnaces, pickering gas furnace problems, whitby furnaces, residential furnace, pickering hvac furnace, pickering furnace service, pickering furnaces, oshawa furnace inspection, oshawa furnaces, gas furnace problems, furnace services oshawa, furnace maintenance near me, furnace repair ajax, furnace repair pickering, furnace repair oshawa, furnace replacement, furnace repairs, furnace repair, furnace installations ajax, furnace installations pickering, furnace installations oshawa, furnace inspection,