$49 / month O.A.C Including Install
$49 / month O.A.C Including Install

24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

CLICK HERE FOR A FREE QUOTATION

If you're looking for help fixing your Heil Air Conditioner, look no further! Our comprehensive Heil Air Conditioner repair guide will explain common issues, provide troubleshooting tips, and show you how to read your model's error codes..


R-410A Split System Heat Pump.

CODE: Green "POWER".
RESULT: Module has power.
FIX: Supply voltage is present at module terminals.

CODE: Red "TRIP".
RESULT: Thermostat demand signal. Y1 is present, but the compressor is not running.
FIX:
  1. Compressor protector is open.
  2. Outdoor unit power disconnect is open.
  3. Compressor circuit breaker or fuse(s) is open.
  4. Broken wire or connector is not making contact.
  5. Low pressure switch open if present in system.
  6. Compressor contactor has failed open.

CODE: Yellow "ALERT" - Flash Code 1.
RESULT: Long Run Time - Compressor is running extremely long run cycles.
FIX:
  1. Low refrigerant charge.
  2. Evaporator blower is not running.
  3. Evaporator coil is frozen.
  4. Faulty metering device.
  5. Condenser coil is dirty.
  6. Liquid line restriction (filter drier blocked if present in system).
  7. Thermostat is malfunctioning.

CODE: Yellow "ALERT" - Flash Code 2.
RESULT: System Pressure Trip - Discharge or suction pressure out of limits or compressor overloaded.
FIX:
  1. High head pressure.
  2. Condenser coil poor air circulation (dirty, blocked, damaged).
  3. Condenser fan is not running.
  4. Return air duct has substantial leakage.
  5. If low pressure switch present in system, check Flash Code 1 information.

CODE: Yellow "ALERT" - Flash Code 3.
RESULT: Short Cycling - Compressor is running only briefly.
FIX:
  1. Thermostat demand signal is intermittent.
  2. Time delay relay or control board defective.
  3. If high pressure switch present go to Flash Code 2 information.
  4. If low pressure switch present go to Flash Code 1 information.

CODE: Yellow "ALERT" - Flash Code 4.
RESULT: Locked Rotor.
FIX:
  1. Run capacitor has failed.
  2. Low line voltage (contact utility if voltage at disconnect is low).
  3. Excessive liquid refrigerant in compressor.
  4. Compressor bearings are seized.

CODE: Yellow "ALERT" - Flash Code 5.
RESULT: Open Circuit.
FIX:
  1. Outdoor unit power disconnect is open.
  2. Compressor circuit breaker or fuse(s) is open.
  3. Compressor contactor has failed open.
  4. High pressure switch is open and requires manual reset.
  5. Open circuit in compressor supply wiring or connections.
  6. Unusually long compressor protector reset time due to extreme ambient temperature.
  7. Compressor windings are damaged.

CODE: Yellow "ALERT" - Flash Code 6.
RESULT: Open Start Circuit. Current only in run circuit.
FIX:
  1. Run capacitor has failed.
  2. Open circuit in compressor start wiring or connections.
  3. Compressor start winding is damaged.

CODE: Yellow "ALERT" - Flash Code 7.
RESULT: Open Run Circuit - Current only in start circuit.
FIX:
  1. Open circuit in compressor run wiring or connections.
  2. Compressor run winding is damaged.

CODE: Yellow "ALERT" - Flash Code 8.
RESULT: Welded Contactor - Compressor always runs.
FIX:
  1. Compressor contactor has failed closed.
  2. Thermostat demand signal not connected to module.

CODE: Yellow "ALERT" - Flash Code 9.
RESULT: Low Voltage - Control circuit < 17VAC.
FIX:
  1. Control circuit transformer is overloaded.
  2. Low line voltage (contact utility if voltage at disconnect is low).


See What Our Customers Are Saying:

by Robert, Pickering on Twintech Heating and Cooling

Had new furnace installed and ran into some difficulties but the contractor responded in a timely and efficient manner - after further service calls were made, a reasonable resolution was found.

by Brian Burns, Whitby on Twintech Heating and Cooling

The work was done quickly efficiently neatly and professionally. Pleased with the service, information, product, and the company.

by Geoff, Port Perry on Twintech Heating and Cooling

Great sales member named Dave came in told us some amazing items and how they would be priced installed an all. We couldn’t believe it! The next day the ac was installed, that day one employee named Greg told us that our furnace was working way to hard and was causing us to use way too much gas. So two days later they came in an installed a new furnace!

by MB, Ajax on Twintech Heating and Cooling

Installation was done quickly and professionally. The new furnace is quiet and provides even heat.

by Richard from Oshawa on Twintech Heating and Cooling

They removed and discarded old furnace. Installed new furnace. Installed air intake pipe, that had never been installed by builder, no charge. Replaced loose hose on floor with hard pipe and rerouted it to drain, no charge. Almost 33% cheaper then quote from Enercare, which was the company we dealt with and had insurance with for 8 years. No yearly fee for cleaning/insurance, saves 300 a year. Courteous, professional, fast, and friendly. My wife and I have been recommending them to everyone we know and meet, and will continue to do so. Thanks for everything, Twintech!!!

by Darcy from Pickering on Twintech Heating and Cooling

This company was great to deal with. Our furnace went down and they installed a new furnace the next day with a lot of professionalism!

by gillian hooton from Uxbridge on Twintech Heating and Cooling

Finally! An honest company with highly knowledgeable and informative staff. Had a furnace service and found multiply errors in our system from an amateur installer. Very fair price to correct problems and will definitely use again.

by dflynn in Ajax on Twintech Heating and Cooling

Had to replace the heating & a/c unit in a condo apartment dwelling. this company recommended by the property manager and president of the condo building. found their workmanship and attention to details very good and very thorough. were able to resolve small problems and situations and happy to feel the heat in my unit. it's pricey, but happy was done by a very professional service. thank you.

by alisiena from Toronto on Twintech Heating and Cooling

Fantastic team. Completed the job as per the specifications and in under 3 hours. Highly recommended Twintech.

by David from Toronto on Twintech Heating and Cooling

During the summer, I previously hired TwinTech to replace my air conditioner when it failed. They did an excellent job so when I decided to proactively replace the furnace I contacted them. The furnace I had was 22 years old and showed signs of internal leakage. It still worked but rather than wait to have it fail in cold weather, I decided to purchase a higher efficiency model before it failed and take advantage of energy efficiency rebates. TwinTech offered very useful advice on the make and model of furnace to choose including high efficiency and variable speed motor. The price was reasonable, TwinTech arrived at the allotted time, installed the new furnace (including some re-routing of exhaust lines since the existing ones were too close to other vents), removed the old furnace, tested the installation and cleaned everything up. Overall, it was a good experience, they did a great job and the new furnace is working well.

See What Our Customers Are Saying:

by Robert Rogers on Twintech Heating and Cooling

Very pleased with the professional service that TwinTech Heating and Cooling provided in replacing my furnace. I got several quotes from different service providers. Their price was excellent and they explained the features very well. We are very glad we went with TwinTech and highly recommend their services.

by Robert Mizuno on Twintech Heating and Cooling

We were new homeowners in need of a second opinion. TwinTech Heating & Cooling were Amazing and professional. Very knowledgeable and great service all around. Recommend to anyone looking for honest and reliable services. Treated with respect and care. Thank you Greg, Mitch and Bob!

by Ruth on Twintech Heating and Cooling

TwinTech is an excellent and honest company! I called them for a second opinion after being told by another company that I needed to replace my furnace. Turns out this was not the case at all! I did not need a new furnace. TwinTech did not push to make an unnecessary sale and saved me from a huge expense. Bob and Mitch were extremely professional and above all honest! I definitely recommend TwinTech!

by Anna Chin on Twintech Heating and Cooling

Amazing experience with TwinTech Heating & Cooling! Their team was professional, knowledgeable, and efficient from start to finish. They installed my new furnace quickly and left everything spotless. The technicians took the time to explain everything and made sure I was comfortable with the system before they left. Great customer service and fair pricing. I highly recommend them for anyone needing HVAC services!

by Connor Agnew on Twintech Heating and Cooling

Great experience all around. Bob was sharp and easy to talk to, and Greg handled the installation perfectly. Would hire them again in a heartbeat.

Are Dirty Air Filters Effecting My Furnace

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - January 2, 2025

Yes, dirty air filters can significantly affect your furnace's performance and efficiency. Here’s how: 1. Reduced Airflow Dirty filters restrict airflow, forcing your furnace to work harder to circulate air through your home. This can

Read More

Is My HVAC System Ready For Spring?

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - March 23, 2025

spring is the perfect time to ensure your HVAC system is in top shape before the warmer weather hits. Here’s a quick checklist to help you figure out if your system is ready: 1. Check and Replace Air Filters Dirty filters restrict airflow

Read More

Is My Furnace Unit Broken?

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - September 24, 2024

If you're wondering whether your furnace unit is broken, here are some signs that may indicate an issue: No Heat or Weak Airflow: If your furnace isn't producing heat or the airflow is weak, there could be a problem with the blower m

Read More

Furnace Installation: The Basics You Need to Know

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - February 21, 2018

If you are planning on having a new furnace installed, then you should know beforehand that it is a big job. If you are planning on installing your new furnace on your own – trust us, DO NOT DO IT. You need to make sure that the installation job is

Read More