Durham Region Air Conditioning Repair, Service and Installation
The flashing LEDs on your furnace will correspond to a specific fault code that is shown here on their diagnostic chart.
If you have a Trane furnace, then you have one of the most reliable heating systems in existence. However, even the most reliable furnace runs into problems from time to time, and this is why your Trane has included several error codes to help you find a given issue. However, if you're unfamiliar with error codes for furnaces, then you may be unaware of what these codes mean.
To get peace of mind, it's important that you take a look at typical Trane furnace error codes to you learn what these error codes mean so you can get your system the service it needs.
CODE: Flashing Slow
RESULT: Normal no call for heat.
FIX: This is only an issue if you have raised your thermostat and your furnace doesn't respond.
RESULT: Normal no call for heat.
FIX: This is only an issue if you have raised your thermostat and your furnace doesn't respond.
CODE: Flashing Fast
RESULT: Normal call for heat.
FIX: Only beware this if your furnace is continuously calling for heat and isn't responding to your thermostat..
RESULT: Normal call for heat.
FIX: Only beware this if your furnace is continuously calling for heat and isn't responding to your thermostat..
CODE: Continuous On
RESULT: Control panel issue.
FIX: Replace Control Panel.
RESULT: Control panel issue.
FIX: Replace Control Panel.
CODE: Continuous Off
RESULT: Check Power.
FIX: Check Power.
RESULT: Check Power.
FIX: Check Power.
CODE: 2 Flashes
RESULT: External Lockout (Retried or recycles exceeded).
FIX: Check for miswiring, clogged pilot tube, or humidity in the unit.
RESULT: External Lockout (Retried or recycles exceeded).
FIX: Check for miswiring, clogged pilot tube, or humidity in the unit.
CODE: 3 Flashes
RESULT: Pressure Switch error.
FIX: Check if the drain tubes are full of moisture or obstructed with dirt.
RESULT: Pressure Switch error.
FIX: Check if the drain tubes are full of moisture or obstructed with dirt.
CODE: 4 Flashes
RESULT: Open high limit device.
FIX: The issue with thermal protection.
RESULT: Open high limit device.
FIX: The issue with thermal protection.
CODE: 5 Flashes
RESULT: Flame sensed when NO flame should be present.
FIX: Check for a leaky gas valve, stuck gas valve, or defective flame sensor.
RESULT: Flame sensed when NO flame should be present.
FIX: Check for a leaky gas valve, stuck gas valve, or defective flame sensor.
CODE: 6 Flashes
RESULT: 115 VAC power reversed polarity or poor grounding.
FIX: Correct line voltage polarity, check the wiring.
RESULT: 115 VAC power reversed polarity or poor grounding.
FIX: Correct line voltage polarity, check the wiring.
CODE: 7 Flashes
RESULT: Gas Valve circuit error.
FIX: Check your unit's gas valves for the issue.
RESULT: Gas Valve circuit error.
FIX: Check your unit's gas valves for the issue.
CODE: 8 Flashes
RESULT: Low Flame sens signal.
FIX: Check for flame sensor malfunction or low gas pressure.
RESULT: Low Flame sens signal.
FIX: Check for flame sensor malfunction or low gas pressure.
CODE: 9 Flashes
RESULT: Check Igniter.
FIX: Check igniter.
RESULT: Check Igniter.
FIX: Check igniter.
See What Our Customers Are Saying:
Jul 2, 2017
Very impressed they arrive to quote even though I had forgotten to call them back to confirm date & time. They showed the day before installation to deliver the unit. Returned the next day as promised at 9am. Project was completed in a professional manner. They even fixed a few things that they noticed were not installed correctly, or to code by previous heating & air contractors we had at our residence before. Would recommend this company to everyone!
Jun 29, 2017
Greg removed old oil furnace and oil tank from basement relocated new Napoleon propane furnace to allow duct work to be rerouted to a much more suitable location. Moved air conditioner to the new furnace. Dave recommended two available grants to assist with cost. They kept to their original quoted price which was substantially lower than a competitors for the same furnace and work. They completed the work as stated when stated and left the area clean and tidy. We are very pleased with the outcome.
Jun 28, 2017
Twintech installed a Goodman furnace and ac init. Very professional install, both units are working well.
Jun 28, 2017
We had Grant and Greg Dainty quote to replace our 20 yr old furnace. I have known them for years and have had other jobs done by them ( AC and Pool Htr). The price was very reasonable and the job was completed in one day.
Jun 23, 2017
TwinTech was the right choice. Our consultation with Dave set the tone. Professional and knowledgeable, we even received a follow-up call within hours of our install completion, wow! TwinTech arrived as scheduled to install our A/C unit. Within minutes of arrival Greg noted and explained a few out of code faults on our furnace installed by another company, problems fixed, thanks TwinTech. Greg, Grant and "Subaru" Pete were meticulous start to finish. Highly recommended!
Jun 13, 2017
Twintech replaced our aging +20 yrs old Furnace & AC with the variable high efficiency Napoleon Furnace matched with the Goodman AC. Sales guy ,Dave was great, gave a no pressure estimate, explained about the Government Rebate program which they took care of completely including arranging the home energy audit. On the scheduled day Greg and his team arrived on time, did a great job and completed the same day , extremely professional and courteous, cleaned up everything , tested the system, Greg took his time to explain the setup. Very impressed with the Napoleon Furnace 9600 which did a great job in maintaining a comfortable temperature last winter and now with the hot weather the Goodman AC cooled the house in much less time than the old AC unit could ever. From start to finish Twintech were great and have no hesitation in recommending them 100%.
Jun 13, 2017
The Twintech team did an excellent job installing our new Goodman air conditioner. They were polite and professional. Greg was knowledgeable and clearly experienced. Thank you Twintech for bringing our cooling system up to current regulations. Job well done!
Jun 11, 2017
Dave from TwinTech was very knowledgeable, professional and thorough in the buying process. He helped us to identify the best furnace for our home and our budget. When we needed a new filter a year later and seemed to have a problem finding the right one, I called Dave up and he delivered a filter to me the next day! The cost was on par with other retailers, but it was this unexpected personal service that really was impressive. The furnace? Works like a charm.
May 27, 2017
Imagine, it's 5 minutes after the midnight countdown New Year's eve and the furnace quits. We called TwinTech fully expecting to leave a message and actually spoke with Greg, one of the owners! We had an immediate repair early the next morning & a new furnace within the week. We have entrusted TwinTech with all our home HVAC service needs for over 6 years. That's why this week with an opportunity to purchase a new BBQ, we called them 1st to see about a gas line install. It's chicken on the grill tonight! They are efficient, reliable, honest, hard working, and -- attentive is an understatement.
Jan 19, 2016
Wonderful customer service, starting from the job quote (Dave), to the clean install, to the follow-up. Twintech is a small company which installed my Napoleon furnace, A/C, John Wood tank, and ran the line for my gas dryer. The installation was completed as promised in one day. The work area was kept very clean, and they even took care of my old rental tank. The professionalism and wonderful customer service is second to none. They completed all of my rebate paperwork, and now I'm getting $2000 back! You will not be disappointed if you hire this company for your project.