Durham Region Air Conditioning Repair, Service and Installation
The flashing LEDs on your furnace will correspond to a specific fault code that is shown here on their diagnostic chart.
If you have a Trane furnace, then you have one of the most reliable heating systems in existence. However, even the most reliable furnace runs into problems from time to time, and this is why your Trane has included several error codes to help you find a given issue. However, if you're unfamiliar with error codes for furnaces, then you may be unaware of what these codes mean.
To get peace of mind, it's important that you take a look at typical Trane furnace error codes to you learn what these error codes mean so you can get your system the service it needs.
CODE: Flashing Slow
RESULT: Normal no call for heat.
FIX: This is only an issue if you have raised your thermostat and your furnace doesn't respond.
RESULT: Normal no call for heat.
FIX: This is only an issue if you have raised your thermostat and your furnace doesn't respond.
CODE: Flashing Fast
RESULT: Normal call for heat.
FIX: Only beware this if your furnace is continuously calling for heat and isn't responding to your thermostat..
RESULT: Normal call for heat.
FIX: Only beware this if your furnace is continuously calling for heat and isn't responding to your thermostat..
CODE: Continuous On
RESULT: Control panel issue.
FIX: Replace Control Panel.
RESULT: Control panel issue.
FIX: Replace Control Panel.
CODE: Continuous Off
RESULT: Check Power.
FIX: Check Power.
RESULT: Check Power.
FIX: Check Power.
CODE: 2 Flashes
RESULT: External Lockout (Retried or recycles exceeded).
FIX: Check for miswiring, clogged pilot tube, or humidity in the unit.
RESULT: External Lockout (Retried or recycles exceeded).
FIX: Check for miswiring, clogged pilot tube, or humidity in the unit.
CODE: 3 Flashes
RESULT: Pressure Switch error.
FIX: Check if the drain tubes are full of moisture or obstructed with dirt.
RESULT: Pressure Switch error.
FIX: Check if the drain tubes are full of moisture or obstructed with dirt.
CODE: 4 Flashes
RESULT: Open high limit device.
FIX: The issue with thermal protection.
RESULT: Open high limit device.
FIX: The issue with thermal protection.
CODE: 5 Flashes
RESULT: Flame sensed when NO flame should be present.
FIX: Check for a leaky gas valve, stuck gas valve, or defective flame sensor.
RESULT: Flame sensed when NO flame should be present.
FIX: Check for a leaky gas valve, stuck gas valve, or defective flame sensor.
CODE: 6 Flashes
RESULT: 115 VAC power reversed polarity or poor grounding.
FIX: Correct line voltage polarity, check the wiring.
RESULT: 115 VAC power reversed polarity or poor grounding.
FIX: Correct line voltage polarity, check the wiring.
CODE: 7 Flashes
RESULT: Gas Valve circuit error.
FIX: Check your unit's gas valves for the issue.
RESULT: Gas Valve circuit error.
FIX: Check your unit's gas valves for the issue.
CODE: 8 Flashes
RESULT: Low Flame sens signal.
FIX: Check for flame sensor malfunction or low gas pressure.
RESULT: Low Flame sens signal.
FIX: Check for flame sensor malfunction or low gas pressure.
CODE: 9 Flashes
RESULT: Check Igniter.
FIX: Check igniter.
RESULT: Check Igniter.
FIX: Check igniter.
See What Our Customers Are Saying:
Jan 1, 2015
Dave was great in helping me get the proper units for my property, as well as getting them installed. The installers arrived when they said they would, and completed the project on time, and professionally. If I needed another furnace, I would use Dave again.
Jan 1, 2015
I have known Greg and Grant Dainty for many years and have used their company for my house and business. I recommended them also for my parents and sister and they all have been very satisfied with the quality of work for a reasonable price. I just recently had them install a new HVAC system in an older house and was very pleased with their work. Craig in Pickering. After meeting with various heating and air conditioning contractors I was referred to Twin Tech Heating and Cooling through a family member. Greg and Grant arrived at my home and provided me with an estimate and a plan as to how they were going to remove and replace my furnace and air conditioner. On the day of install Greg and Grant arrived at my home on time and were very professional and extremely courteous as to any questions or concerns that I had. The removal and install was truly professional and the attention to detail was exactly what I was looking for. Ive seen many installs from other contractors and I couldnt be any happier to have had such a clean looking install. The sheet metal work, ducting and venting all look fantastic. Upon completion Greg and Grant left me feeling extremely happy and very fortunate of a job well done. Thanks again Twin Tech!!
Jan 1, 2015
My old furnace had finally broken down for the last time when contacted twintech to have a new furnace installed They were prompt, knowledgeable and very reasonably priced. They did such a great job i tell all my friends and family about this company.
Jan 1, 2015
To whom it may concern, I recently had TwinTech (Greg and Grant Dainty) replace my furnace and service both my gas fireplaces and air conditioning unit. They were professional, courteous and very fair in their pricing. I would gladly recommend TwinTech to anyone needing work done. I can be contacted at 905-626-XXXX.
Jan 1, 2015
My Fiancé and I have relied on Twintech Heating and Cooling now for the better part of the last 10 years. In that time, Greg has installed a furnace, an air conditioner, and a heat-pump at our residence in Toronto. In each instance Greg and his team were a pleasure to deal with. They were courteous and professional throughout the whole process and the quality of their work is first rate. Our experiences have always been extremely positive and we have referred his services numerous times to our friends and family. Without hesitation, I would recommend Greg and TwinTech Heating and Cooling to anyone looking to service or replace their existing heat/AC equipment