$49 / month O.A.C Including Install
$49 / month O.A.C Including Install

5 Things You Should Know When Installing an Air Conditioner

24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832


[BACK]
5 Things You Should Know When Installing an Air Conditioner

Posted On: June 23, 2022

5 Things You Should Know When Installing an Air Conditioner

With the heat of the summer approaching, you may be looking to buy a new Central air conditioner.


Here are some tips to help you get the job done right! Today’s residential air conditioning systems are not as simple to install as they may appear.


Merely connecting all the tubing and wiring is just the beginning.


Beyond that, there are several important steps in the installation that can either make it or break it for you!


Here are 5 very important things that need to be done properly for your new air conditioner to last a long time.


This is how we do it day in and day out.


Number 1 - The installation of the evaporator coil (usually above your furnace) is a crucial part of a good install.


It must be installed in a way that directs all the air flowing out of your furnace, through the new matching evaporator coil.


This ensures that no air is flowing around it.


Also, the air leaks in the sheet metal work should be sealed with tape or sealant made for this purpose.


In the field, we often see an installation where the coil is mounted so that much of the air is flowing around the coil, which was never right to begin with.


We use 26 Gage Galvanized Metal Angle for this purpose because we come prepared to do it right.


Number 2 - The airspeed needs to be set at approximately 350 to 400 CFM per ton for air conditioning to work as it was designed to.


This is a very important step that is needed later when testing the level of “charge in your new system.


" Also, be sure to know the type of restrictor device your system has.


Is it a piston-type or a TXV (THERMOSTATIC EXPANSION VALVE)? It is not unusual, on a service call, to see that an installer has left the furnace fan speed set in the factory position, which is usually too high and a good indication that the charge was never checked when the AC was installed.


There can be a more negative effect on piston-type systems if the airflow is too high or low.


Systems equipped with a TXV also need to have the “bulb” installed in the correct location and orientation.


So many times, when removing someone’s old system we see the bulb still sitting in the shipping location, which means it was never working right from day one.


Number 3 - With today’s systems running on R410a refrigerant, it is more important than ever to have inert gas such as NITROGEN flowing through the copper tubing.


This is used to move the refrigerant from the outside unit (condenser) through the inside unit (evaporator).


The reason for this is that oxides can occur from the brazing process, and they contaminate the new system before it even starts.


This result can result in poor performance and a short life span of your new air conditioner.


Number 4 - It is important to test your new system for leaks before starting it up for the first time.


This is a two-part process that we follow on every installation.


The first step in this process is to pressure test all the welded joints, and since we are using NITROGEN for brazing, we just leave it connected to your new system.


Then, we pressurize the evaporator and new copper line welds up to 200 PSI for a few minutes.


If there is a leak, it will show on the gauge, and you may even be able to hear it if it's big enough.


It's not uncommon to have a small leak at this time because sometimes the position of the joint is difficult to access.


So by using NITROGEN as a first step, the system can be pre-approved as leak-free.


Number 5 - The final step we take, for all new installations or on any repair calls, is to use a Micron gauge to prove that the new system is 100 percent leak-free.


We pull our vacuums down to 250 microns using a properly calibrated digital gauge.


You cannot pull a deep vacuum, such as this, with any kind of small leak or non-condensable in the lines.


Once we establish the deep vacuum, then and only then, do we release the refrigerant from the new AC condenser that comes with a factory charge, which is usually sufficient for installations.


The final part of the start-up process is to measure the charge to ensure it is within the manufacturers' specifications.


We use digital gauges, which measure all the important things needed to be certain the system is right on the money, such as using a superheat calculation for piston-type systems and sub-cooling for systems equipped with a TXV.


We usually end up either having to add a bit of refrigerant to the system or remove a bit of refrigerant depending on the length of the tubing or other variables to dial in the charge just right.


Sometimes it takes an extra bit of time but now you are ready to enjoy many years of trouble-free air conditioning to keep your home comfortable through the hottest days of the season.



[BACK]

See What Our Customers Are Saying:

by Jennifer in Toronto on Twintech Heating and Cooling

I had cold and hot spots all over my 70 yr old home. My furnace is quite new and Greg optimized the fan and furnace. The original installer just took it out of the box with factory settings and installed it- basically running at 50% of capacity. Greg also routed heat into my laundry room, yeah - so now I can renovate laundry room - thanks Greg. He is honest, professional and knowledgeable. I will be calling him back in the spring to optimize my AC as well.

by Happy Homeowner in Toronto on Twintech Heating and Cooling

Wonderful from beginning to end. I tend to fret and worry about home improvements but the excellent team at TwinTech put my mind as ease. They listen, they are patient and best of all ... the work they did is amazing! I chose the Goodman 80K BTU 2 stage furnace and the matching Goodman air conditioner. Greg, Grant and Poitr "Peter" arrived on time, took great care, explained everything to me and they answered all of my questions. They carefully adjusted the factory settings to optimize the furnace for my house and they also checked the duct work in the basement. Dave, the Sales Manager, came by to say "hello" and to see if I was happy. YES, I am happy with the work! The furnace is very quiet. I have it running on low just to circulate the air in the house and it's so much quieter than my old furnace. When I need new duct work for an upcoming basement renovation TwinTech will be my first choice. I highly recommend TwinTech. PS. They were even nice to my dogs.

by Les G. from Pickering on Twintech Heating and Cooling

Greg was prompt on the scheduled day of installation and the work was done well within the time estimated beforehand. Installation was neat and the equipment and scope of work was as specified in the quote. One item I must point out is that we were faced with a "No Heat" situation the day before the scheduled installation and Greg came out to address it free of charge. Not only that, but he also corrected an installation fault with our smart thermostat that was not part of the original job, again free of charge.

by one19 in North york on Twintech Heating and Cooling

Greg came by to do a routine furnace checkup. He was very knowledgeable and professional, letting me know what's being checked/adjusted and giving me tips to ensure everything runs smooth. Very honest and upfront about what's working fine vs. what may need to be fixed/replaced. He didn't attempt to up sell anything that wasn't necessary. I'm glad to have finally found someone I can trust and rely on for all my HVAC needs - furnace, A/C, and hot water tank.

by Paul M. from Toronto on Twintech Heating and Cooling

I'm very happy with the work that was done. Everyone from salesperson to the installers were friendly and professional. They were on time and cleaned up the job site after it was installed. They also answered all my follow up questions promptly. I wouldn't hesitate to work with them or recommend them again.

by Kathy D.in Ajax on Twintech Heating and Cooling

Thanks to the team at Twin Tech for a great job installing my new heat pump/ac unit. The guys were very polite and professional. When they left you would never have known they had been there except for the new Mitsubishi unit on the wall!! would highly recommend the Twin Tech team.

by varga p. in Pickering on Twintech Heating and Cooling

Installed professionally, no delays, no rework needed. Very reliable contractor and sales person. Also installed BBQ gas line and some duct work.

by Private User on Twintech Heating and Cooling

Greg and Grant are friendly, reliable, and knowledgeable HVAC professionals. The twins, Dave and the entire team provided efficient top quality service. Our family plns to use Twintech for all of our future HVAC needs.

by peter in Whitby on Twintech Heating and Cooling

Very impressed with this company. They show up on time , kept my place clean and after they left it looks like they were never there. Very professional team. Those people know what they doing . Their installation was on the highest standard. They are very knowledgeable especially they're worker Peter. I strongly recommend this company to everybody. After the installation I receive the call making sure I'm satisfied with their products and their job. Bravo!!!

by James in Bowmanville on Twintech Heating and Cooling

Greg and his brother were referred to us by a friend. They arrived when they said they would, did an exceptional job and left the place as tidy or tidier then they found it. Their professionalism is only surpassed by their kind and friendly demeanor. Even after several calls to help me with my high tech thermostat I feel that I could always call with any concern (No one responds to my texts as quickly as Greg) and have a friendly helpful response. I found out their grandfather started the company and now as a 3rd generation company, they are doing their grandfather proud. I would highly recommend Twintech over any other hvac company out there.

Related Links:
ac repair services, furnace repairs pickering, central air conditioner services, whitby air and heating, whitby heating and air, ajax hvac repair, air conditioner repair, hvac repairs, heating repair company, house air conditioner repair, ac repair and service, whitby air conditioning, residential air conditioner repair, residential ac repair, pickering air conditioners, oshawa air conditioners, nearby ac repair, furnace repair ajax, furnace repair pickering, furnace repair oshawa, furnace repairs, furnace repair, hvac repair service, central air conditioner, ajax furnace repair, ajax air conditioners,


See What Our Customers Are Saying:

by Robert Rogers on Twintech Heating and Cooling

Very pleased with the professional service that TwinTech Heating and Cooling provided in replacing my furnace. I got several quotes from different service providers. Their price was excellent and they explained the features very well. We are very glad we went with TwinTech and highly recommend their services.

by Robert Mizuno on Twintech Heating and Cooling

We were new homeowners in need of a second opinion. TwinTech Heating & Cooling were Amazing and professional. Very knowledgeable and great service all around. Recommend to anyone looking for honest and reliable services. Treated with respect and care. Thank you Greg, Mitch and Bob!

by Ruth on Twintech Heating and Cooling

TwinTech is an excellent and honest company! I called them for a second opinion after being told by another company that I needed to replace my furnace. Turns out this was not the case at all! I did not need a new furnace. TwinTech did not push to make an unnecessary sale and saved me from a huge expense. Bob and Mitch were extremely professional and above all honest! I definitely recommend TwinTech!

by Anna Chin on Twintech Heating and Cooling

Amazing experience with TwinTech Heating & Cooling! Their team was professional, knowledgeable, and efficient from start to finish. They installed my new furnace quickly and left everything spotless. The technicians took the time to explain everything and made sure I was comfortable with the system before they left. Great customer service and fair pricing. I highly recommend them for anyone needing HVAC services!

by Connor Agnew on Twintech Heating and Cooling

Great experience all around. Bob was sharp and easy to talk to, and Greg handled the installation perfectly. Would hire them again in a heartbeat.

When to Rest Your Furnace Unit

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - October 17, 2024

Resting your furnace unit is essential to ensure its longevity, efficiency, and to avoid overworking the system. Here are some key times when you should consider giving your furnace a break: During mild weather: When temperatures are moderat

Read More

Expert Heat Pump Installation in Whitby

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - April 14, 2025

Expert Heat Pump Installation in Whitby - Twintech Heating & Cooling If you're looking for reliable and energy-efficient heat pump installation in Whitby, look no further than Twintech Heating & Cooling. As a trusted name in the HVA

Read More

A Homeowner’s Basic Guide to Heat Pumps

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - May 23, 2025

If you’re looking for an efficient way to heat and cool your home, heat pumps are an option worth considering. These all-in-one systems provide year-round comfort while helping you save on energy bills. But what exactly is a heat pump, an

Read More

My Furnace Needs Fixing!

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - October 29, 2024

Let's get that furnace sorted! Here are some steps you can take to troubleshoot and potentially fix the issue: Check Your Thermostat: Sometimes, it’s as simple as the thermostat being off or set to the wrong temperature. Make sure

Read More