$49 / month O.A.C Including Install
$49 / month O.A.C Including Install

24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

CLICK HERE FOR A FREE QUOTATION

If you're looking for help fixing your coleman furnace, look no further! Our comprehensive coleman furnace repair guide will explain common issues, provide troubleshooting tips, and show you how to read your model's error codes.


CODE: Slow green flashing.
RESULT: Coleman furnace is operating normally.
FIX: N/A.

CODE: Slow amber flashing.
RESULT: Normal operation with a call for heat.
FIX: N/A.

CODE: Steady on red.
RESULT: There's a control failure.
FIX: Check Control Unit.

CODE: Rapid red flashing.
RESULT: There's a twinning error with incorrect 24V phasing.
FIX: Check the twinning wiring.

CODE: Rapid amber flashing.
RESULT: There's a low flame sense current.
FIX: Check and clean the flame sensor. If it's still an issue, check for proper gas flow.

CODE: One red flash.
RESULT: A flame's present with the gas turned off.
FIX: Check the gas valve. It could be leaky or slow closing.

CODE: Two red flashes.
RESULT: Pressure switch is stuck in the closed position.
FIX: Check if there is a faulty pressure switch or miswiring.

CODE: Three red flashes.
RESULT: Pressure switch is stuck in the open position.
FIX: Check if there is a faulty inducer, a blocked vent pipe, a broken pressure switch hose, or a faulty pressure switch.

CODE: Four red flashes.
RESULT: Limit switch is stuck while open.
FIX: Check for a a dirty filter, an improperly sized duct system, an incorrect blower speed setting, or a faulty blower motor.

CODE: Five red flashes.
RESULT: Rollout switch is stuck while open.
FIX: The rollout control is manually reset. Therefore, if it has opened, then check to see if the inducer is operating properly or there is an issue with the primary heat exchanger.

CODE: Six red flashes.
RESULT: Pressure switch cycle has locked out.
FIX: The furnace will lockout for one hour and then reset.

CODE: Seven red flashes.
RESULT: There's an ignition lockout due to too many retries.
FIX: The flame couldn't be established, check for a faulty gas valve, a dirty or defective flame sensor, a faulty hot surface ignitor, or a problem with the burner.

CODE: Eight red flashes.
RESULT: There's an ignition lockout due to repeated power recycles.
FIX: Check if there is low gas pressure, a dirty or defective flame sensor, or a faulty gas valve.

CODE: Nine red flashes.
RESULT: There's a grounding or line polarity issue.
FIX: Check the polarity at both the furnace and branch.

CODE: Ten red flashes.
RESULT: Gas continues to flow with no call for heating.
FIX: Check on the gas valve and the gas valve wiring.


See What Our Customers Are Saying:

by Eric Y, Greenbank on Twintech Heating and Cooling

Dave was great in helping me get the proper units for my property, as well as getting them installed. The installers arrived when they said they would, and completed the project on time, and professionally. If I needed another furnace, I would use Dave again.

by Ed B., Whitby on Twintech Heating and Cooling

I have known Greg and Grant Dainty for many years and have used their company for my house and business. I recommended them also for my parents and sister and they all have been very satisfied with the quality of work for a reasonable price. I just recently had them install a new HVAC system in an older house and was very pleased with their work. Craig in Pickering. After meeting with various heating and air conditioning contractors I was referred to Twin Tech Heating and Cooling through a family member. Greg and Grant arrived at my home and provided me with an estimate and a plan as to how they were going to remove and replace my furnace and air conditioner. On the day of install Greg and Grant arrived at my home on time and were very professional and extremely courteous as to any questions or concerns that I had. The removal and install was truly professional and the attention to detail was exactly what I was looking for. I’ve seen many installs from other contractors and I couldn’t be any happier to have had such a clean looking install. The sheet metal work, ducting and venting all look fantastic. Upon completion Greg and Grant left me feeling extremely happy and very fortunate of a job well done. Thanks again Twin Tech!!

by Floreene in Whitby on Twintech Heating and Cooling

My old furnace had finally broken down for the last time when contacted twintech to have a new furnace installed…They were prompt, knowledgeable and very reasonably priced. They did such a great job i tell all my friends and family about this company.

by Damien McIsaac. Ajax on Twintech Heating and Cooling

To whom it may concern, I recently had TwinTech (Greg and Grant Dainty) replace my furnace and service both my gas fireplaces and air conditioning unit. They were professional, courteous and very fair in their pricing. I would gladly recommend TwinTech to anyone needing work done. I can be contacted at 905-626-XXXX.

by Blair N. - Toronto on Twintech Heating and Cooling

My Fiancé and I have relied on Twintech Heating and Cooling now for the better part of the last 10 years. In that time, Greg has installed a furnace, an air conditioner, and a heat-pump at our residence in Toronto. In each instance Greg and his team were a pleasure to deal with. They were courteous and professional throughout the whole process and the quality of their work is first rate. Our experiences have always been extremely positive and we have referred his services numerous times to our friends and family. Without hesitation, I would recommend Greg and TwinTech Heating and Cooling to anyone looking to service or replace their existing heat/AC equipment

See What Our Customers Are Saying:

by Aaron on Twintech Heating and Cooling

We are very happy to recommend this company to everyone. Our furnace broke down on Sunday morning. We phoned them and before noon Grant the owner showed up. He worked on the furnace for about a hour not wanting to give up to fix the problem. The furnace was 17 years old. I was the one talking about replacing it. End result was the next day it was all done. On the Sunday Bob came over with heaters to warm up the house. We decided to replace the water heater at the same time. Thanks Grant for the excellent work. Thumbs up.

by Linda on Twintech Heating and Cooling

Right on time. Explained how to work the HRV in a different way so the house would not be so dry. Changed my whole house water filter for me as well. Friendly, helpful, caring service!

by Robert Rogers on Twintech Heating and Cooling

Very pleased with the professional service that TwinTech Heating and Cooling provided in replacing my furnace. I got several quotes from different service providers. Their price was excellent and they explained the features very well. We are very glad we went with TwinTech and highly recommend their services.

by Robert Mizuno on Twintech Heating and Cooling

We were new homeowners in need of a second opinion. TwinTech Heating & Cooling were Amazing and professional. Very knowledgeable and great service all around. Recommend to anyone looking for honest and reliable services. Treated with respect and care. Thank you Greg, Mitch and Bob!

by Ruth on Twintech Heating and Cooling

TwinTech is an excellent and honest company! I called them for a second opinion after being told by another company that I needed to replace my furnace. Turns out this was not the case at all! I did not need a new furnace. TwinTech did not push to make an unnecessary sale and saved me from a huge expense. Bob and Mitch were extremely professional and above all honest! I definitely recommend TwinTech!

Intermittent Igniter Issues (natural gas, Armstrong Air Ultra V)

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - March 26, 2023

Here's the sitch.I've replaced my igniter 3-4 times in the last year. Figured I'd just gotten cheap ones. Maybe I got oil on it, maybe chemicals/moisture from nearby washing machine/shower (there's talk of this online, idk). Anyway, I bought a beefie

Read More

My AC is Not Blowing Cold Air

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - May 7, 2024

There could be several reasons why your air conditioner isn't blowing cold air. Here are a few common issues and troubleshooting steps: Thermostat Settings: Make sure your thermostat is set to "cool" mode and the temperature is

Read More

Common Ways Your AC Might Break Down

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - May 18, 2024

Air conditioning systems are essential for maintaining comfort in hot weather, but they can encounter various issues that lead to breakdowns. Understanding the common causes of AC failures can help you take preventive measures and ensure timely repai

Read More

Furnace: Upgrade to a Smart Thermostat

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - February 9, 2025

Upgrading to a smart thermostat for your furnace can improve efficiency, comfort, and energy savings. Here’s why you should consider making the switch: Benefits of a Smart Thermostat for Your Furnace ✅ Energy Efficiency – Smart th

Read More