$49 / month O.A.C Including Install
$49 / month O.A.C Including Install

24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

CLICK HERE FOR A FREE QUOTATION

If you're looking for help fixing your napoleon air conditioner, look no further! Our comprehensive napoleon air conditioner repair guide will explain common issues, provide troubleshooting tips, and show you how to read your model's error codes.


PROBLEM: Unit will not operate,
RESULT: Power disconnected or loose connection.
FIX: Check power supply to unit. Check voltage at contactor.

PROBLEM: Unit will not operate,
RESULT: Blown fuse / breaker tripped.
FIX: Replace fuses/reset breaker.

PROBLEM: Unit will not operate,
RESULT: Thermostat out of calibration is set too high.
FIX: Reset.

PROBLEM: Unit will not operate,
RESULT: Contactor defective.
FIX: Check for 24VAC at contactor coil - replace if open.

PROBLEM: Unit will not operate,
RESULT: Transformer defective.
FIX: Check wiring - replace transformer.

PROBLEM: Unit will not operate,
RESULT: High pressure control open (if provided).
FIX: Reset - see high pressure connection.

PROBLEM: Outdoor fan on; Compressor off.
RESULT: Run or start capacitor defective.
FIX: Replace.

PROBLEM: Outdoor fan on; Compressor off.
RESULT: Start relay defective.
FIX: Replace.

PROBLEM: Outdoor fan on; Compressor off.
RESULT: Loose wire.
FIX: Check for correct voltage at compressor - check and tighten all connections.

PROBLEM: Outdoor fan on; Compressor off.
RESULT: Compressor stuck, grounded or open motor winding, open internal overload.
FIX: Wait at least 2 hours for overload to reset; if still open, replace the compressor.

PROBLEM: Too little cooling.
RESULT: Low voltage condition.
FIX: Add start kit components.

PROBLEM: Too little cooling.
RESULT: Improperly sized unit.
FIX: Recalculate load.

PROBLEM: Too little cooling.
RESULT: Improper indoor airflow.
FIX: Check-should be approximately 400 CFM per ton.

PROBLEM: Too little cooling.
RESULT: Incorrect refrigerant charge.
FIX: Charge per procedure in installation manual.

PROBLEM: Too little cooling.
RESULT: Air, non-condensables or moisture in system.
FIX: Recover refrigerant.

PROBLEM: Compressor operates in short cycles.
RESULT: Incorrect voltage.
FIX: At compressor terminals, voltage must be +/10% of nameplate marking when unit is operating.

PROBLEM: Compressor operates in short cycles.
RESULT: Defective overload protector.
FIX: Replace - check for correct voltage.

PROBLEM: Compressor operates in short cycles.
RESULT: Refrigerant undercharge.
FIX: Add refrigerant.

PROBLEM: High head pressure; Low suction pressure.
RESULT: Restriction in liquid line, expansion device or filter drier.
FIX: Remove or replace defective component.

PROBLEM: High head pressure; Low suction pressure.
RESULT: Lack of sufficient indoor airflow.
FIX: Clean/check filters, registers, or evaporator coil that may cause a restriction.

PROBLEM: High head pressure; Normal suction pressure.
RESULT: Dirty outdoor coil.
FIX: Clean coil.

PROBLEM: High head pressure; Normal suction pressure.
RESULT: Refrigerant overcharge.
FIX: Correct system charge.

PROBLEM: High head pressure; Normal suction pressure.
RESULT: Outdoor fan not running.
FIX: Repair or replace.

PROBLEM: High head pressure; Normal suction pressure.
RESULT: Air or non-condensables in system.
FIX: Recover refrigerant, evacuate and recharge.

PROBLEM: Low head pressure; High suction pressure.
RESULT: Expansion device stuck in open position.
FIX: Replace expansion device.

PROBLEM: Low head pressure; High suction pressure.
RESULT: Defective compressor valves.
FIX: Replace compressor.

PROBLEM: Low suction pressure; Compressor cool. Ice on indoor coil.
RESULT: Low indoor airflow.
FIX: Increase speed of blower or reduce restriction - replace air filter.

PROBLEM: Low suction pressure; Compressor cool. Ice on indoor coil.
RESULT: Operating below 65F (18C) outdoors.
FIX: Add low ambient kit.

PROBLEM: Low suction pressure; Compressor cool. Ice on indoor coil.
RESULT: Moisture in system.
FIX: Recover refrigerant - evacuate and recharge - replace filter drier.

PROBLEM: High suction pressure; or fluctuating head and suction pressures.
RESULT: Excessive load.
FIX: Recheck load calculation.

PROBLEM: High suction pressure; or fluctuating head and suction pressures.
RESULT: Defective compressor.
FIX: Replace.

PROBLEM: High suction pressure; or fluctuating head and suction pressures.
RESULT: TXV hunting.
FIX: Check TXV bulb clamp - check air distribution on coil - replace TXV.

PROBLEM: High suction pressure; or fluctuating head and suction pressures.
RESULT: Air or non-condensables in system.
FIX: Recover refrigerant, evacuate and recharge.

PROBLEM: Pulsing noise at expansion device or liquid line.
RESULT: Air or non-condensables in system.
FIX: Recover refrigerant, evacuate and recharge.

PROBLEM: Registers sweat.
RESULT: Low indoor airflow.
FIX: Increase speed of blower or reduce restriction - replace air filter.


See What Our Customers Are Saying:

by Bill, Oshawa on Twintech Heating and Cooling

We are very happy with our new furnace. The service was excellent the guys worked 6 hours straight through and there was no mess at all they took the old furnace box’s etc with them they then explained everything to us they were very helpful and pleasant , when we need a new air conditioner we know who to call!

by Ken, Bomanville on Twintech Heating and Cooling

The crew from sales to installation was very professional and had great attention to detail

by Tracy, Pickering on Twintech Heating and Cooling

We couldn’t have been more impressed with Twintech - from our first service call with Mitch who took the time to thoroughly diagnose the issue with our furnace, to Dave who proposed a well thought out solution to meet our needs and finally Greg and team who acted quickly to install given we had no heat.


We did our due diligence by soliciting quotes from alternate providers and were shocked and disappointed by the aggressive and manipulative tactics used.


Twintech was honest in their approach, detailed in their product knowledge, reasonably priced, diligent in their follow-up and valued our business.


Well done Twintech! You made this a positive experience for us and our new furnace works beautifully!

by Skapoor, Ajax on Twintech Heating and Cooling

We recently purchased an Amana high efficiency furnace and humdifier through Twintech. The work was completed very professionally and the quality of the workmanship was high. There was some additional sheet metal work required to complete the installation, which they were able to complete themselves. Overall I am very pleased with the work and would highly recommend Twintech for a furnace replacement.

by Steve, Oshawa on Twintech Heating and Cooling

We were very pleased with every aspect of the work that was done. They were very professional and polite. They arrived when they said they would and job was completed on estimated time


We would highly recommend them to whoever needed a recommendation


We have a very large dog and they were very understanding and respectful of him being around

by Patrick, Toronto on Twintech Heating and Cooling

The blower on our furnace stopped working leaving us with a cold house. Dave from TwinTech responded immediately to our HomeStars service request. From beginning to end Dave was nothing but helpful, friendly and professional, he did a great job of walking us through the quote and scope of work.


The replacement of the furnace went smoothly. The Guys did a great job, everyone was very friendly and polite. There were no hiccups, or unexpected costs. The only surprise was they left the work area cleaner than it was before they started.


Was a great experience with the whole TwinTech team. Its been a couple of months since the new furnace has been installed and its working great!

by Ed, Whitby on Twintech Heating and Cooling

I heard about TwinTech when researching new furnaces at furnaceprices.ca. After contacting them about my broken down furnace, Dave came to my house the next day to assess my situation and requirements for a new furnace. He recommended one that had stainless steel heat exchangers which sold me since my previous furnace had issues with a rusted secondary heat exchanger that had to be replaced. Dave also set me up with an appointment with an energy audit company so that I could take advantage of a rebate to help improve the energy efficiency of my home and get some money back. A few days later, Greg, Grant, and Mitch came to install the new furnace and remove the old one. When delivering and removing the furnaces, they were very careful not to damage my floors and walls, and even laid out red carpeting to protect the floors. They were very friendly and professional. The installation was completed in the time they said it would take and they cleaned up their work areas. Within a week, Dave called to follow-up to see how everything was going. I have already recommended them to several friends and family members who may need new furnaces soon.

by Fred, Toronto on Twintech Heating and Cooling

Twintech did a great job, from Dave the Sales Rep to the Office staff and The Professional Technicians who did the installation. They were professional, courteous, knowledgable and informative. From beginning to follow up we were completely satisfied with everything. Thanks Again. Sincerely The Laytons

by Elle, Oshawa on Twintech Heating and Cooling

Great product, great service, great follow-up. The Twintech Heating and Cooling arranged removal of my existing oil tank and they installed the new gas furnace Amana (made in USA). I am very happy with the final result and support I received throughout the process. My thanks go to the entire Twintech team for their professionalism, great communication and follow-up.

by John & Linda, Ajax on Twintech Heating and Cooling

We've had Twintech provide us with work in the past, for an inground pool heater and required rough-in for a new gas stove. More recently they provided the same friendly, professional, timely and clean installation of our new furnace.

See What Our Customers Are Saying:

by Aaron on Twintech Heating and Cooling

We are very happy to recommend this company to everyone. Our furnace broke down on Sunday morning. We phoned them and before noon Grant the owner showed up. He worked on the furnace for about a hour not wanting to give up to fix the problem. The furnace was 17 years old. I was the one talking about replacing it. End result was the next day it was all done. On the Sunday Bob came over with heaters to warm up the house. We decided to replace the water heater at the same time. Thanks Grant for the excellent work. Thumbs up.

by Linda on Twintech Heating and Cooling

Right on time. Explained how to work the HRV in a different way so the house would not be so dry. Changed my whole house water filter for me as well. Friendly, helpful, caring service!

by Robert Rogers on Twintech Heating and Cooling

Very pleased with the professional service that TwinTech Heating and Cooling provided in replacing my furnace. I got several quotes from different service providers. Their price was excellent and they explained the features very well. We are very glad we went with TwinTech and highly recommend their services.

by Robert Mizuno on Twintech Heating and Cooling

We were new homeowners in need of a second opinion. TwinTech Heating & Cooling were Amazing and professional. Very knowledgeable and great service all around. Recommend to anyone looking for honest and reliable services. Treated with respect and care. Thank you Greg, Mitch and Bob!

by Ruth on Twintech Heating and Cooling

TwinTech is an excellent and honest company! I called them for a second opinion after being told by another company that I needed to replace my furnace. Turns out this was not the case at all! I did not need a new furnace. TwinTech did not push to make an unnecessary sale and saved me from a huge expense. Bob and Mitch were extremely professional and above all honest! I definitely recommend TwinTech!

Pickering Furnace Leaking

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - January 19, 2025

If you’re dealing with a furnace leaking water in Pickering, you’re not alone. This common issue can lead to water damage and disrupt your heating system’s efficiency. At Twintech Heating and Cooling, we understand how crucial a pro

Read More

Thinking about Switching from a Ducted HVAC System to Ductless Mini Splits

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - August 11, 2023

I have been looking into purchasing a heat pump for the last few months. I love DIY, but for this project, I had always assumed I would have an HVAC company do the installation. My initial impression was that I would replace my existing AC/gas

Read More

Understanding Furnace Zoning Issues

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - December 23, 2024

Furnace zoning is a modern HVAC strategy designed to improve comfort and energy efficiency by dividing a home into separate zones, each with its own thermostat. However, while zoning offers several benefits, issues can arise that affect system perfor

Read More

Why Buy a Heat Pump For My Whitby Home

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - April 27, 2025

When it comes to keeping your Whitby home comfortable year-round, choosing the right HVAC system is crucial. One of the most efficient and versatile options available today is the heat pump. At Twintech Heating and Cooling, we believe a heat pu

Read More