$49 / month O.A.C Including Install
$49 / month O.A.C Including Install

24 / 7 Emergency Service Available. Call Us Now: 1.844.894.6832

Durham Region Air Conditioning Repair, Service and Installation

CLICK HERE FOR A FREE QUOTATION

If you are an owner of Ruud furnace or operate it at your work, you may encounter with Ruud furnace error codes appearing in the operation process. The tables on the page describe the codes, flashes, blinks and other problem signals and let you understand what is going on with the equipment at a certain moment.


Ruud R801T Furnace Error Code

CODE: 0.
RESULT: Standby.

CODE: C.
RESULT: Compressor on (cooling or heat-pump heat).

CODE: H.
RESULT: Gas heat on.

CODE: F.
RESULT: Continuous fan on.

CODE: 10.
RESULT: 1 hour lockout.

CODE: 11.
RESULT: Failed ignition.

CODE: 12.
RESULT: Low flame sense.

CODE: 13.
RESULT: Flame lost.

CODE: 14.
RESULT: Unexpected flame.

CODE: 20.
RESULT: Twinning fault.

CODE: 22.
RESULT: Main limit open.

CODE: 26.
RESULT: Line and neutral reversed.

CODE: 33.
RESULT: Mrlc (manual reset limit control) (aka roll-out) open.

CODE: 55.
RESULT: Pressure switch stuck closed when should be open.

CODE: 57.
RESULT: Press switch stuck open when should be closed.

CODE: 61.
RESULT: Blower fault-blower unable to run.

CODE: 93.
RESULT: Internal control fault.

Ruud U98V Furnace Error Code

FLAME LED: OFF.
RESULT: No flame is detected.

FLAME LED: Rapid blink.
RESULT: Unexpected flame.

FLAME LED: Slow blink.
RESULT: Marginal flame sense.

FLAME LED: Steady ON.
RESULT: Normal flame detected.

STATUS LED: Steady ON.
RESULT: Furnace.

STATUS LED: 1 Blink.
RESULT: Ignition failure, 1 HR lockout.
FIX: Reboot system.

STATUS LED: 2 Blinks.
RESULT: Pressure switch stuck open, switch will not close when inducer is on.
FIX: Try to manually close the switch, replace the switch, or check blowers and vents for air pressure.

STATUS LED: 3 Blinks.
RESULT: Limit switch open, main limit or roll out control
FIX: Check for a restricted air vent, loose blower wheel, a defective blower, or a dirty air filter.

STATUS LED: 4 Blinks.
RESULT: Pressure switch stuck closed, switch will not open.
FIX: Check for an obstruction in the pressure tubing.

STATUS LED: 5 Blinks.
RESULT: Not applicable.

STATUS LED: 6 Blinks.
RESULT: Line and neutral reversed.
FIX: Control board or the furnace's ground could be defective.

POWER LED: OFF.
RESULT: No power (24 VAC) to control board.

POWER LED: ON.
RESULT: Control is powered.

Ruud R802P Furnace Error Code

FLAME LED: OFF.
RESULT: No flame is detected.

FLAME LED: Rapid Blink.
RESULT: Unexpected Flame.

FLAME LED: Slow Blink.
RESULT: Marginal Flame Sense.

FLAME LED: Steady ON.
RESULT: Normal Flame Detected.

STATUS LED: Steady ON.
RESULT: Normal Fault detected.

STATUS LED: 1 Blink.
RESULT: Ignition failure, 1 HR lockout.

STATUS LED: 2 Blinks.
RESULT: Pressure switch stuck open switch will not close when inducer is on.

STATUS LED: 3 Blinks.
RESULT: Limit switch open main limit or roll-out control.

STATUS LED: 4 Blinks.
RESULT: Pressure switch stuck closed. Switch will not open.

STATUS LED: 5 Blinks.
RESULT: Not applicable.

STATUS LED: 6 Blinks.
RESULT: Line and Neutral reversed.

POWER LED: OFF.
RESULT: No power (24VAC) to control board.

POWER LED: ON.
RESULT: Control is powered.

Ruud R96P Furnace Error Code

GREEN LED: ON.
RESULT: Normal operation.

GREEN LED: 1 Flash.
RESULT: Ignition failure (4 trials).

GREEN LED: 2 Flashes.
RESULT: Pressure switch stuck open.

GREEN LED: 3 Flashes.
RESULT: Limit switches open.

GREEN LED: 4 Flashes.
RESULT: Pressure switch stuck closed.

GREEN LED: 5 Flashes.
RESULT: Twin fault.

GREEN LED: 6 Flashes.
RESULT: Brownout voltage.

GREEN LED: 7 Flashes.
RESULT: Hot and neutral reversed or no ground.

GREEN LED: Continuous.
RESULT: Gas valve relay short.

YELLOW LED: Rapid Blink.
RESULT: Flame out of sequence.

YELLOW LED: Slow Blink.
RESULT: Low flame or no flame.

YELLOW LED: ON.
RESULT: Flame present.


See What Our Customers Are Saying:

by Bill, Oshawa on Twintech Heating and Cooling

We are very happy with our new furnace. The service was excellent the guys worked 6 hours straight through and there was no mess at all they took the old furnace box’s etc with them they then explained everything to us they were very helpful and pleasant , when we need a new air conditioner we know who to call!

by Ken, Bomanville on Twintech Heating and Cooling

The crew from sales to installation was very professional and had great attention to detail

by Tracy, Pickering on Twintech Heating and Cooling

We couldn’t have been more impressed with Twintech - from our first service call with Mitch who took the time to thoroughly diagnose the issue with our furnace, to Dave who proposed a well thought out solution to meet our needs and finally Greg and team who acted quickly to install given we had no heat.


We did our due diligence by soliciting quotes from alternate providers and were shocked and disappointed by the aggressive and manipulative tactics used.


Twintech was honest in their approach, detailed in their product knowledge, reasonably priced, diligent in their follow-up and valued our business.


Well done Twintech! You made this a positive experience for us and our new furnace works beautifully!

by Skapoor, Ajax on Twintech Heating and Cooling

We recently purchased an Amana high efficiency furnace and humdifier through Twintech. The work was completed very professionally and the quality of the workmanship was high. There was some additional sheet metal work required to complete the installation, which they were able to complete themselves. Overall I am very pleased with the work and would highly recommend Twintech for a furnace replacement.

by Steve, Oshawa on Twintech Heating and Cooling

We were very pleased with every aspect of the work that was done. They were very professional and polite. They arrived when they said they would and job was completed on estimated time


We would highly recommend them to whoever needed a recommendation


We have a very large dog and they were very understanding and respectful of him being around

by Patrick, Toronto on Twintech Heating and Cooling

The blower on our furnace stopped working leaving us with a cold house. Dave from TwinTech responded immediately to our HomeStars service request. From beginning to end Dave was nothing but helpful, friendly and professional, he did a great job of walking us through the quote and scope of work.


The replacement of the furnace went smoothly. The Guys did a great job, everyone was very friendly and polite. There were no hiccups, or unexpected costs. The only surprise was they left the work area cleaner than it was before they started.


Was a great experience with the whole TwinTech team. Its been a couple of months since the new furnace has been installed and its working great!

by Ed, Whitby on Twintech Heating and Cooling

I heard about TwinTech when researching new furnaces at furnaceprices.ca. After contacting them about my broken down furnace, Dave came to my house the next day to assess my situation and requirements for a new furnace. He recommended one that had stainless steel heat exchangers which sold me since my previous furnace had issues with a rusted secondary heat exchanger that had to be replaced. Dave also set me up with an appointment with an energy audit company so that I could take advantage of a rebate to help improve the energy efficiency of my home and get some money back. A few days later, Greg, Grant, and Mitch came to install the new furnace and remove the old one. When delivering and removing the furnaces, they were very careful not to damage my floors and walls, and even laid out red carpeting to protect the floors. They were very friendly and professional. The installation was completed in the time they said it would take and they cleaned up their work areas. Within a week, Dave called to follow-up to see how everything was going. I have already recommended them to several friends and family members who may need new furnaces soon.

by Fred, Toronto on Twintech Heating and Cooling

Twintech did a great job, from Dave the Sales Rep to the Office staff and The Professional Technicians who did the installation. They were professional, courteous, knowledgable and informative. From beginning to follow up we were completely satisfied with everything. Thanks Again. Sincerely The Laytons

by Elle, Oshawa on Twintech Heating and Cooling

Great product, great service, great follow-up. The Twintech Heating and Cooling arranged removal of my existing oil tank and they installed the new gas furnace Amana (made in USA). I am very happy with the final result and support I received throughout the process. My thanks go to the entire Twintech team for their professionalism, great communication and follow-up.

by John & Linda, Ajax on Twintech Heating and Cooling

We've had Twintech provide us with work in the past, for an inground pool heater and required rough-in for a new gas stove. More recently they provided the same friendly, professional, timely and clean installation of our new furnace.

See What Our Customers Are Saying:

by Aaron on Twintech Heating and Cooling

We are very happy to recommend this company to everyone. Our furnace broke down on Sunday morning. We phoned them and before noon Grant the owner showed up. He worked on the furnace for about a hour not wanting to give up to fix the problem. The furnace was 17 years old. I was the one talking about replacing it. End result was the next day it was all done. On the Sunday Bob came over with heaters to warm up the house. We decided to replace the water heater at the same time. Thanks Grant for the excellent work. Thumbs up.

by Linda on Twintech Heating and Cooling

Right on time. Explained how to work the HRV in a different way so the house would not be so dry. Changed my whole house water filter for me as well. Friendly, helpful, caring service!

by Robert Rogers on Twintech Heating and Cooling

Very pleased with the professional service that TwinTech Heating and Cooling provided in replacing my furnace. I got several quotes from different service providers. Their price was excellent and they explained the features very well. We are very glad we went with TwinTech and highly recommend their services.

by Robert Mizuno on Twintech Heating and Cooling

We were new homeowners in need of a second opinion. TwinTech Heating & Cooling were Amazing and professional. Very knowledgeable and great service all around. Recommend to anyone looking for honest and reliable services. Treated with respect and care. Thank you Greg, Mitch and Bob!

by Ruth on Twintech Heating and Cooling

TwinTech is an excellent and honest company! I called them for a second opinion after being told by another company that I needed to replace my furnace. Turns out this was not the case at all! I did not need a new furnace. TwinTech did not push to make an unnecessary sale and saved me from a huge expense. Bob and Mitch were extremely professional and above all honest! I definitely recommend TwinTech!

Window AC making room more humid

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - August 9, 2023

I have a Midea 5000 btu air conditioner and when it kicks off the humidity quickly rises to about 80% then when it comes back on it drops back into the 60s, why is it doing this Question from user busnerd20 at AirConditioners at reddit. Answer

Read More

Benefits of an Indoor A/C Unit

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - September 19, 2023

Indoor air conditioning units, also known as ductless mini-split systems or ductless air conditioners, offer several benefits for cooling indoor spaces. Here are some of the advantages of using an indoor A/C unit: Zoned Cooling: Ductless min

Read More

Panasonic Heat Pump Rebates Durham Region

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - June 30, 2025

If you’re considering upgrading your home’s heating and cooling system in the Durham Region, a Panasonic heat pump is one of the most efficient and eco-friendly choices available. At Twintech Heating & Cooling, we specialize in pro

Read More

Why Isn't My Heat Pump Turning On?

  • SUBMITTED BY:
  • TWINTECH HEATING & COOLING
  • - October 28, 2023

If your heat pump is not turning on, there could be several reasons for this issue. Here are some common troubleshooting steps to help you identify and potentially resolve the problem: Check the Thermostat: Ensure that the thermostat

Read More